Promet TC-1995 User manual

Assembly instruction for Tool Cabinets
TC-1095 and TC-1995
TC-1995 TC-1095
A
View A
TC-1995
TC-1095
х 3
х 4
1
Left back panel
Right back panel
Bolt M5
Guidance before assembly
1. Attentively read the instruction.
2. To avoid any damages of lacquer coating, implement assembly of a cabinet on a soft
non-abrasive surface (linoleum, carpet or protective cardboard).
3. For the cabinet assembly you will need a Phillips screwdriver.
Revision level 23.01.14
2
1
25-35
roof
doorstep
cover
axis
axis
damper
left door
bush for bolt
doorstep
cover
Door installation procedure:
1. Insert the spring axes into the roof’s holes and in the holes of the doorstep cover
of the cabinet.
2. Fix the door on the lower axis.
3. Bring the upper door’s angle to the axis, “drown” the axis’ rod and install the
door. The axis should “click” in the door’s hole.
Note. Before installing the door be sure that the axis’ rod goes freely into the holes, and
if necessary, clean the holes of the paint.
1. After installing the doors insert bushes for bolt into the roof’s holes and into the
holes of the doorstep cover.
2. Stick the dampers on the lower and the upper parts of the left door (see picture).
The dampers can be not stuck if the lock is closed smoothly, without jamming.
Notes to the instruction.
1. Assembly sequence is specified by the ordinal number in the left bottom corner of
each picture of the assembly operation.
2. Type and quantity of the mounting products for the assembly operation are specified
in the upper left corner of its picture.
Recommendation for cabinet exploitation.
1. The cabinet installation should be implemented on a flat horizontal surface.
2. It is recommended to begin filling the cabinet (by docs etc.) from the lower part of
the cabinet.
3. It is recommended to evenly spread the weight over the shelves’ surface for the
optimal load of the mounting elements.
Notes
1. Constructive changes, not noted in this instruction, are possible.

B
х 6
TC-1095
TC-1995
х 8
View B
Left side panel Right side panel
Bolt М5
2
hook
1.5 +1
Doorstep’s
body
C
View C
TC-1095
TC-1995
х 6
х 4
4
Bolt М5
Before the installation of the doorstep’s body turn the hooks back so that there will
be a gap (1.5-2.5) mm.
Bottom
panel
Right
panel
Hitch
Bottom
panel
5
1. Install the bottom panel so that
side and back bendings go into the
hitches of the side and back panels.
2. Important: The front bending
must be necessarily installed into the
hooks of the doorstep’s body,
otherwise the bottom panel can be
damaged when it’s uploaded.
Doorstep’s
body
doorstep
cover
Look after the doorstep cover so that it is installed correctly! It must be “clicked”.
3
3
D
View D
2
1
TC-1995
х 4
х 4
TC-1095
x 2
x 2
4
Side
panel
roof
Corner’s
bolt
Butterfly nut M5
6
1. Install the roof so that the bolts on the roof go into
the holes on the side panels (see View D)
2. The panels should go into the gap between the
roof’s corner and the lateral roof bending.
3. Note: To make the roof installation easier, pull the
back panels back and push down on the roof so that
it sets on the side panels tightly.
back
panels
roof
Pull
back
Push
down
Push
down
Рис. 6а