Proshade 1031593 User manual

R
3.42M / 11FT CANTILEVER PATIO UMBRELLA WITH BASE
ITM. / ART. 1031593/1500309
ASSEMBLY INSTRUCTIONS
IMPORTANT, RETAIN FOR FUTURE REFERENCE:
READ CAREFULLY
For assistance with assembly, parts, or problem resolution please contact customer
service in US and Canada at 1-877-730-1583, 9:00AM - 5:00PM EST, Monday - Friday,
English, French, and Spanish spoken or visit proshade.com.
E
THIS ITEM IS INTENDED FOR OUTDOOR DOMESTIC USE ONLY,
NOT FOR COMMERCIAL USE
1
CARE INSTRUCTION:
FRAME: To clean, use a mild detergent and warm water on the frame.
Do not use abrasive materials or cleaners.
CANOPY: Wash with a mild solution of soap and water.
Rinse thoroughly and drip-dry in an open position.
CAUTION:
Place the base in the desirable location for use before filling with
sand and water. After filling with sand and water, base is not easy to move.
To avoid personal injury or damage to the umbrella, make sure the
area around you is clear from any outdoor structure or furniture.
Umbrella should be closed or stored indoors during windy conditions.
Do not use during severe weather conditions.
Keep all flame and heat sources away from this umbrella.
Use umbrella cover only when umbrella is completely dry.

PARTS LIST FOR ASSEMBLING
10
1
2
3
4
5
6
7
8
13
14
9
11
12
Note: Parts 11-14 are packed in box 2 of 2.
1. Head Hinge
2. Sliding Tube
3. Slide Stopper
4. Sliding Support Tube
5. Crank hole for moving umbrella pole up and down
6. Crank hole for opening and closing umbrella
7. Crank Handle
8. Lower Umbrella Pole
9. Locking Ring
10. Umbrella Canopy
11. Nut
12. Standing Tube
13. Fixed Ring
14. Base
2 3
A
B
C
D
E
F
G
H
I
J
4K
1
1
1
1
1
1
1
1
1
1
Umbrella Cover
Support Rod
Pole
Base
Standing Tube
Fixed Ring
Nut
Operation Manual
Umbrella Cover
Hardware Package
Lower Umbrella Pole
Frame and Canopy
QTY
DESCRIPTION
P
NO. ARTS LIST
NOTE: Parts shown on part list are not to scale.
Parts available for replacement

ASSEMBLING THE BASE
5
J
6
Remove standing tube . Reinstall base cover.
WARNING: Keep the standing tube straight!
Fillthe base completely with 90 kg / 200 lb sand, then add water
to wet down the sand.
Remove the standing tube carefully (step 5) to avoid sand into
the center of the base shell.
Caution:
4
12
5
ASSEMBLING THE BASE
1
14
12
12
2
3
4
Remove base cover. Insert standing tube .
Fill base withsand.
It is recommended to
use 90 kg / 200 lb of sand.
Add water to wet the sand.

ASSEMBLING THE BASE
Make certain the base is securely placed on flat surface
before inserting the umbrella.
Only use the base provided with this umbrella. Other bases
may not fit with this umbrella and could cause a safety issue.
6 7
ASSEMBLING THE BASE
DO NOT fasten the nut tightly or
the lower umbrella pole can't be
inserted into the base.
8
Fixed Ring :Make sure the side
with thread is facing upwards.
7
13
13
9
8
13
Make sure the thread of fixed ring
and locking ring are matched.
10
9
Turn pole clockwise.
11
11
8

ASSEMBLING THE UMBRELLA
2
It is recommended to use 2 people when placing
the umbrella in the base.
8 9
ASSEMBLING THE UMBRELLA
1
*Bolt not flush
Notch to align
Align the bolt which is not flush with the notch inside the upper frame.
*

1
10
TILTING THE UMBRELLA
2
T
Umbrella can move back to fully open status if turn the crank clockwise.
urn the crank
desired position when it is fully opened.
counter-clockwise to tilt the umbrella to
11
7
OPERATING THE UMBRELLA
OPENING UMBRELLA
12
Once the umbrella is fully opened, do not
continue to turn crank , otherwise the
stopping mechanism will not function properly.
Caution:Do not open the umbrella
before the sliding tube tis fu ly ex ended.
Otherwise the parts wil
l
l be damaged.
Fully extend sliding tube before opening umbrella.
7
2

UMBRELLA LIGHT INSTALLATION
(UMBRELLA LIGHT IS NOT INCLUDED)
43
21
12
ROTATING THE UMBRELLA
Release the nut by
turning counter-clockwise.
Caution:Only rotatetheumbrella in its closed position.
Turn the lower umbrella pole
to your desired position,
then lock the nut.
13
11
11
8

CLOSING THE UMBRELLA
1
2
14
CLOSING THE UMBRELLA
3
Caution
Do not close the canopy before the sliding tube is fully extended.
Otherwise the umbrella parts will not function properly.
15
10 2

UMBRELLA COVER
Umbrella Cover
Support Rod
Umbrella Cover
16
3.42M / 11FT CANTILEVER PATIO UMBRELLA WITH BASE
LETTER OF WARRANTY
ITM. / ART.
1031593 / 1500309
Please be advised that the manufacturer provides a two-year warranty that the
3.42m / 11ft Cantilever Patio Umbrella with Base will be free from defects in
original materials and workmanship
Frame
Frames are warranted to be free from defects in materials and workmanship for
a period of two years. Damage to frames or welds due to improper assembly or
exposure to water and sub-freezing temperatures is not covered. Do not allow
water to accumulate inside frames.
Finish
The finish is warranted against peeling, cracking, or blistering for a period of
two years, provided the unit has not been scratched or abraded. Scratches and
chips resulting from abnormal wear and tear are not covered. Fading resulting
from exposure to elements is not covered.
Fabric
Fabric is warranted for a period of two years against separation at the seams.
Fading or discoloration resulting from exposure to the elements, chemicals,
or from spills is not covered.
AUSTRALIA: Our goods come with guarantees that cannot be excluded under
the Australian Consumer Law. You are entitled to a replacement or refund for
a major failure and for compensation for any other reasonably foreseeable loss
or damage. You are also entitled to have the goods repaired or replaced if the
goods fail to be of acceptable quality and the failure does not amount to a major
failure.
Note:All operation should be according to the instruction manual.
* This warranty DOES NOT COVER the following items:
Failure caused by unreasonable or abusive use; failure caused by neglect of
reasonable and necessary care; acts of nature (including but not limited to wind,
hurricanes, tornadoes, and storms) are not covered by this warranty.
The product is not covered by this warranty after two years from the date
of purchase.
17
Use umbrella cover only when umbrella is completely dry.

Pour obtenir de l'aide pour l'assemblage, les pièces ou la résolution de
problèmes, contactez le service clientèle aux États-Unis et au Canada au
1-877-730-1583, entre 9 h et 17 h (HE), de lundi à vendredi, en anglais, français
et espagnol, ou rendez-vous sur proshade. com.
R
PARASOL EXCENTRÉ DE 3,42 M (11 PI) AVEC BASE
ITM. / ART. 1031593/1500309
INSTRUCTIONS D’ASSEMBLAGE
IMPORTANT, À CONSERVER POUR DE FUTURS BESOINS DE
RÉFÉRENCE : À LIRE SOIGNEUSEMENT
CET ARTICLE EST CONÇU UNIQUEMENT POUR UNE
UTILISATION À L'EXTÉRIEUR NON COMMERCIALE.
F1


Mettre la base à l'endroit voulu pour l'utilisation avant de la remplir de sable et
d'eau. Une fois remplie de sable et d'eau, la base est difficile à déplacer.
Pour éviter les blessures personnelles ou les dommages au parasol, s'assurer
que le parasol est loin de structures ou de meubles extérieurs.




AG28-AIS
A
B
C
D
E
F
G
H
I
J
K 4
1
1
1
1
1
1
1
1
1
1
2 3
Pièces de rechange offertes
10
1
2
3
4
5
6
7
8
13
14
9
11
12

4 5
17
1
14
12
2
3
SAND
4
WATER


(12)
5
J
6



12
(12)

6 7

8

7
13

10
9

11
(13)
(9)
(13)
(11)
(8)
(8)



89

1
* Vis saillante
Encoche d’alignement
Aligner la vis saillante avec l’encoche à l’intérieur du mât supérieur.
2


10 11

2
1
12



(2)
(7)

12 13



43
21

14 15
3

1
2

16
17
2PARASOL EXCENTRÉ DE 3,42 M (11 PI) AVEC BASE
ITM. / ART.
1031593/1500309
Le fabricant offre pour le Parasol excentré de 3,42 m (11 pi) avec base
une garantie de deux ans contre les défauts de fabrication et de matériaux
d’origine.
AUSTRALIE : Nos articles sont offerts avecdesgarantiesqui ne peuvent connaître
d'exclusions au regard de la loi australienne sur la protection desconsommateurs.
Vous avez droit au remplacement ou au remboursement en cas de défaillance majeure
de votre article ainsi qu'à une compensation en cas de perte ou de dommage
prévisible. Vous avez aussi droit à la réparation ou au remplacement de l'article s'il
n'est pas d'une qualité acceptable et que la défaillance n'est pas majeure.
L’armature est garantie pendant deux ans contre les défauts de matériaux
et de fabrication.
Le fini est garanti contre l’écaillage, le fendillement et la formation de bulles
pendant deux ans, pourvu que le produit n’ait pas été égratigné ou abrasé.
Ne p
Les coutures sont garanties pendant deux ans.
as laisser l'eau s'accumuler
dans les tuyaux de parasol.
Le produit ne sera deuxième année après la date d’achat.

Le parapluie peut revenir à l'état complètement ouvert si
vous tournez la manivelle dans le sens des aiguilles d'une montre


INSTRUCCIONES DE CUIDADO:




ARMAZÓN: Para limpiar, utilice un detergente suave y agua tibia. No utilice
limpiadores
Use la funda de la sombrilla sólo cuando la sombrilla esté completamente seca.
La sombrilla debe cerrarse o guardarse en el interior durante vientos fuertes.
No la use durante condiciones de clima severo.
o materiales abrasivos.
TOLDO: Lave con una solución de agua y jabón suave.
Enjuague bien y deje secar en posición abierta.
PRECAUCIÓN:
Coloque la base en la ubicación en la que desea usarla, para llenarla con arena y
agua. Después de rellenar la base con arena y agua no será fácil moverla.
Para evitar lesiones personales o daños a la sombrilla, asegúrese que el área
que le rodea esté libre de cualquier estructura exterior o mobiliario.
Mantenga la sombrilla alejada de fuentes directas de calor o llamas.



1
R
ITM. / ART. 1031593/1500309
IMPORTANTE, CONSERVE PARA REFERENCIA FUTURA:
LEA CUIDADOSAMENTE
ESTE PRODUCTO ESTÁ DISEÑADO PARA USO
DOMÉSTICO SOLAMENTE, NO PARA USO COMERCIAL.
Para obtener ayuda con el montaje, las piezas o la resolución de
problemas, comuníquese con el servicio al cliente en EE. UU. y
Canadá al teléfono 1-877-730-1583, de 9:00 a.m. a 5:00 p.m. EST, de lunes
a viernes, en inglés, francés y español, o visite proshade. com.
S
SOMBRILLA VOLADIZA PARA PATIO DE 3.42M CON BASE

32
LISTA DE PIEZAS
10
1
2
3
4
5
6
7
8
13
14
9
11
12
1. Bisagra del Cabezal
2. Tubo Deslizante
3. Tope de Deslizamiento
4. Tubo de Soporte Deslizante
5. Orificio de la Manivela para Mover el
Poste de la Sombrilla Arriba y Abajo
6. Orificio de la Manivela para Abrir y
Cerrar la Sombrilla
7. Manija de la Manivela
8. Poste Inferior de la Sombrilla
9. Anillo de Seguridad
10. Toldo de la Sombrilla
11. Tuerca
12. Tubo Recto
13. Anillo Fijo
14. Base
AG28-AIS
A
B
C
D
E
F
G
H
I
J
K 4
1
1
1
1
1
1
1
1
1
1
Varilla de soporte de
la Funda de la Sombrilla
Poste
Base
Tubo Recto
Anillo Fijo
Tuerca
Manual de Operación
Funda de la
Sombrilla
Paquete de
Accesorios
de Ferretería
Poste Inferior
de la Sombrilla
Armazón y Toldo
CANT.
DESCRIPCIÓN
LISTA DE PIEZAS
NOTA: Las piezas mostradas en el listado no están a escala.
Piezas disponibles para repuesto