Proshade 966762 User manual

10/9/2014 Page 1 of 4
3.36 M / 11 FT / 11 PI MARKET UMBRELLA WITH TILT
ASSEMBLY INSTRUCTIONS
IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY
ITM. /ART. 966762
CAUTION:
The umbrella should be lowered and
secured in windy conditions or when not in use.
Important Information:
Umbrella ribs may compress during shipping. Please
read these instructions before opening your umbrella to
avoid causing permanent damage.
For customer service in the US and Canada, call: 1-877-730-1583 Customer service hours are 9:00am - 5:00pm Monday – Friday (EST) English and French Spoken
Care Instruction:
Wash umbrella canopy with a mild solution of soap and
water. Rinse thoroughly. Drip-dry in open position. Do not
use bleach or solvents on fabric or aluminum frame. Keep
closed when not in use. Not recommended for use in patio
tables. If used in a patio table, always use with an
umbrella base and lower in windy conditions.

Page 2 of 4
TO ASSEMBLE THE UMBRELLA TO OPEN THE UMBRELLA
You must have your umbrella securely
fastened into a prepared umbrella base after
attaching the finial to the top of the umbrella.
Before opening your umbrella, gently pull
apart and separate the ribs into their natural
open position (see Fig 2).
Pull down the rope until you see the lower hole or upper hole on the tilt, then insert
the pin into the hole. At that time, the umbrella is fully open and ready to use.
A
A
A
B
AB
10/9/2014
( Fig. 2) ( Fig. 3) ( Fig. 4)

Page 3 of 4
TO TILT THE UMBRELLA
Fix the umbrella pole firmly into an umbrella stand and rotate the canopy clockwise or counterclockwise to your desired position.
Continue rotating the canopy to move umbrella into its upright position.
TO CLOSE THE UMBRELLA
Hold the rope firmly and remove the pin, then release the rope slowly until the umbrella is fully closed. Use tie straps to secure umbrella
canopy.
10/9/2014
( Fig. 5)
( Fig. 7) ( Fig. 8)
( Fig. 6)
MADE IN CHINA

3.36 M / 11 FT / 11 PI MARKET UMBRELLA WITH TILT
LETTER OF WARRANTY
ITM. /ART. 966762
Please be advised that the manufacturer provides a one-year warranty that the 3.36 m / 11 ft / 11 pi Market Umbrella with Tilt will be free
from defects in original materials and workmanship.
Frame
Frames are warranted to be free from defects in materials and workmanship for a period of one year. Damage to frames due to improper
assembly or exposure to water and sub-freezing temperatures is not covered.
Finish
The finish is warranted against peeling, cracking, or blistering for a period of one year provided the unit has not been scratched or
abraded. Scratches and chips resulting from abnormal wear and tear are not covered. Fading resulting from exposure to elements is not
covered.
Fabric
Fabric is warranted for a period of one year against separation at the seams. Fading or discoloration resulting from exposure to the
elements, chemicals, or from spills is not covered.
Note: All operation should be according to the instruction manual.
* This warranty DOES NOT COVER the following items:
Failure caused by unreasonable or abusive use; failure caused by neglect of reasonable and necessary care; acts of nature (including
but not limited to wind, hurricanes, tornadoes, and storms) are not covered by this warranty. The product is not covered by this
warranty after one year from the date of purchase.
If you have any questions, please call our Customer Service in the US and Canada at 1-877-730-1583, 9:00am - 5:00pm,
Monday - Friday (EST) English and French spoken.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or
refund for a major failure and for compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the
goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
Page 4 of 410/9/2014