Modular Matrix Switcher 16x16
PTN Electronics Limited 6www.PTN-electronics.com
Example: To transfer input 1 to output 1,8,15, you need to press
this button between each two output channels.
Confirmation button: Confirm the switching operation. The
operation will not be executed by the matrix without confirmation.
All button: To transfer an input channel to all output channels.
Example1: To transfer video and audio signals from input channel
No.12 to all output channels
Operation: Press buttons in this order “12”, “ALL”
Example2: To transfer all input signals to the corresponding output
channels respectively. In another word, to switch to this status:
1->1, 2->2, 3->3, 4->4…16->16.
Operation: Press buttons in this order “ALL”, “THROUGH”
Through button: To transfer the signals directly to the
corresponding output channels
Example: To transfer the signals from input channel No. 3 to their
corresponding output channels
Operation: Press buttons in this order “3”, “THROUGH”
Undo button: To resume to the status before the command just
performed
Backspace button: To backspace the latest input button
Switching Operation:
With the front control panel, the MMX matrix could be control directly and rapidly by
pressing the buttons under below format.
“Input Channel”+ “Switch Mode”+“Output Channel”+“Enter”
1) “Switch Mode”: Audio & Video synchronal or break away switching mode, which
includes button “AV”.
2) “Input Channel”: Fill with the number of input channel to be controlled,
3) “Output Channel”: Fill with the number of output channels to be controlled.
4) MMX1616 needs to use “,” button to separate multiple outputs, and “ENTER”button
to confirm the operation.
5) The input/output channels on the rear panel are counting from left to right,
top to bottom. And if the input/output channel is two digits number, the input
delay time between two numbers must less than 5 seconds; otherwise the
operation will be cancelled.
