PUK LANE ROUND 01 User manual

ASSEMBLY AND OPERATING INSTRUCTIONS:
Made in Italy
-COD. 604001
-COD. 604002
LANE ROUND 01
-Power consumption: 10W
-Voltage : 220-240V 50-60H
-Color Temperature : 3000K
-Beam angle : 360°
-Insulation class: I
-IK rating : IK07
-IP protection: IP65
-Gross weight: 2.6kg
COD. 604001
In the case of glass breakage, contact the device manufacturer
to replace it. Replace the screen with an original replacement
-getting rid of as urban waste forbidden
-separate collection is mandatory when the product is at the end of its
life
-Class I fitting electric gruonding is needed
IP65
NB: The appliance mu t not be tampered with or tran formed and it mu t be in talled and u ed a upplied and in compliance with the
National Rule on In tallation . Any non-compliant in tallation will invalidate all form of guarantee. The company cannot be held
re pon ible for damage cau ed by incorrect a embly.
COD. 604002 LANE ROUND 02
-Power consumption Cod. 601603 : 10W
-Voltage : 220-240V 50-60H
-Color Temperature : 3000K
-Beam angle : 360°
-Insulation class: I
-IK rating : IK07
-IP protection: IP65
-Gross weight: 3.5kg
600mm
Ø140mm
Ø140mm
800mm

Recommendation
1) verify that the equipment used to connect our devices to enjoy
all the guarantees required under European law;
2) use the cables, connectors and quality materials for electrical wiring;
3) Products with IP65 degree make the wiring / connections with accessories
provide the same degree IP of the selected product (available in the catalog);
4) In the case of installations outside is not recommended to install the power supplies in the
formwork and / or in the junction box without adequate protection
Note on corro ion protection
For installation and maintenance be especially careful not to damage the coating powder . Damage combined action of water could cause
corrosion.
-In the case of damage to the external flexible cable, it must be replaced by the manufacturer, or its assistance service, or equivalent quali-
fied personnel in order to avoid dangers
-In the case of glass breakage, contact the device manufacturer to replace it. Replace the screen with an original replacement
-Terminal block not incuded. Installation may requireadvice from a qualified person. For wiring use a terminal complies with EN60998-2-1,
EN 60998-2-2.The IP rating of the electrical connection must be equal to or greater than the IP rating of the luminaire.
U e only upply cable with
double ca e
Do not u e water high
pre ure cleaner
Installation
1. Loose the two grub-screws in the base of the luminaire and remove the fixing plate pic.1
2. Prepare holes diam 8mm (distance 90mm) in corrispondance of the feeding point using plugs included in the packa-
ge pic. 2
3. Make the adeguate electrical connection pic. 3
4Fix the base to the floor by tighten the nuts of the plugs pic. 4
5 Place the luminaire by tighten the two grub-screws using the tool included in the package pic. 5
 


