Pulsar 3x20 B User manual

Monocular Pulsar
3x20 B
Manual

Content
Description
Specifications
Package Contents
Monocular Installation
Legal Compliances and Disclaimers

Description
Themonocular Pulsar 3x20 B converts Krypton and Proton devices into
handheld thermal imaging monoculars with 3x magnification.
The monocular is installed on the thermal imaging module without the use
of an additional adapter.

Specifications
3x20 B
Model 3x20 B
SKU 71014
Magnification, х 3
Lens diameter, mm/inch 20/0.79
Field-of-view, deg 15
Eye Relief, mm/inch 20/0.79
Eyepiece Focusing Range,
Diopter ±5
Dimensions, mm/inch 95x45x51 / 3.74x1.77x2
Weight, kg/oz 0.1 / 3.53

Package Contents
Monocular Pulsar 3x20 B
Carrying Case
Neck Strap
Quick Start Guide
Warranty Card
Lens-Cleaning Cloth
Allen Key

Monocular Installation
1. Align the protrusions on the monocular(1) on the side of its lens with the
grooves of the mount (2) of the thermal imaging module.
2. Turn the monocular clockwise to secure it on the thermal imaging
module. The recommended position of the clamping screw (3) is at the
bottom (see Figure).
3. Turn on the thermal imaging module.

4. Adjust the eyepiece diopter ring (4)until the symbols in the display are
sharp.
5.Loosen the screw(3) with an Allen key S3.
6. Align the display to the centre of the image in the monocular by tilting
the thermal imaging module in the required directions.
7. Lock the monocular in the chosen position by tightening the screw(3)
until it stops (clamping force – 2.5 Nm/ 22.13 in-lbs).
8. To remove the monocular, turn it counterclockwise and disconnect from
the thermal imaging module.

Legal Compliances and
Disclaimers
The manufacturer reserves the right at any time, without mandatory notice,
to make changes to the package contents, design and characteristics that
do not impair the quality of the product.
For technical support please contact [email protected].
Answers to frequently asked questions about the devices can also be found
in the FAQ section.