PureEffect ULTRA User manual

1
Thank you, and Congratulations on your purchase of The PureEffectTM ULTRA Water Filtration System
Featuring our: All-Natural FluorSorbTM Anti-Fluoride, AntiRad-PlusTM Anti-Radiation, SuperBlockTM Anti-
Chemical, KDF55®Heavy Metal Filtration and Natural Alkalization Technologies.
INSTALLATION INSTRUCTIONS
(Please read carefully)
Carefully remove and inspect your new filter system for any possible transportation damage. If
any damage is found, please notify us promptly.
1. ❏Unscrew the housing chambers with included wrench and remove the cartridges.
Position filter unit on your kitchen countertop close enough to the sink to ensure that any
excess water coming out of spout will drain properly. *Keep filter out of direct sunlight.
2. ❏Unscrew your existing faucet aerator head and replace it with the included Diverter
Valve (see diagram below), hand tighten. You may need an adapter (included)
depending on faucet type. *Plumbers Tape around the threading can help if there are
any leaks.
3. ❏Turn unit upside down and find the flow indicators “IN” and “OUT” engraved into the
plastic near each port. Screw the Plastic Water-In Elbow into the “IN” port & Spout
Elbow into the “OUT” port,then insert Spout into Spout Elbow. (If you need to
position unit on left side of your sink, switch the wall-mount bracket from back to front of
unit, then turn unit around).
Customer Support:
Tel: [phone]
Email: [email protected]
www.PureEffectFilters.com
Spout Elbow !
“OUT”
Spout !
"Water-In Elbow
“IN”

2
4. ❏Next, Insert one end of the provided Tubing into the “Water In elbow” until it “pops-
in” as far as it can go, then measure how much tubing you will need to comfortably reach
the faucet diverter valve and attach to diverter by: unscrewing the metal ring (off the
diverter output) and putting the tubing through the ring, then attach the tube and screw
ring back on to secure. (note: make sure to factor in enough “slack” in tubing for when
you move your faucet around.
5. ❏Remove shrink wrapping and insert the first two cartridges only: SuperBlockTM
Cartridge into Chamber # 1 and FluorSorbTM Cartridge into Chamber #2 and screw
the chambers closed, close Chamber # 3 empty for now (do not over tighten chambers).
Initiate cartridge flush, instructions on next page.
IMPORTANT! –PLEASE ENSURE CARTRIDGES ARE INSERTED IN
CORRECT ORDER!
#3 #2 #1
AntiRad-PlusTM | FluorSorbTM | SuperBlock TM
Close this last
chamber empty
for now.

3
INITIAL CARTRIDGE FLUSH AND SYSTEM LEAK TEST
Note: You may want to place something under the unit to collect the water, if there’re any
leaks or when you unscrew the chamber for step D., or just keep the unit in the sink during
this process:
A. Slowly turn on cold water, check faucet diverter valve for watertight seal (O-
ring gasket seal should be included in the top of your diverter valve).
B. With your cold water on, turn the white Diverter Valve Handle up, this will
bypass your faucet and redirect the water flow to your filter and out of the Spout. *Note:
you may hear a slight “hissing” sound when the filter is working, this is normal and is
due to the built-in flow-regulator.
C. Check for any leaks on all connection points to ensure watertight connection.If
there are leaks at input or output ports: try to screw the spout elbow and “water-in”
elbow a bit tighter, as well as ensure that the white tubing is pushed as far as it can go
into the “water-in” elbow.
D. As the first water begins to flow, you may notice some grey carbon dust pass
through as the cartridges get flushed. Allow the cold water to run on full for 5minutes
then turn off faucet. Remove Shrink Wrap and add the last cartridge (AntiRad-PlusTM)
to Chamber #3 and screw chamber closed, flush the system for an additional 10 minutes.
THE FILTER SYSTEM IS DESIGNED FOR COOL - COLD WATER USE ONLY.
Note:
The Water may be cloudy during first few
seconds of every use for about a week as the
Zeolite in this cartridge adapts and releases
harmless mineral fines.This will subside in
about a week.
AntiRad-Plus
#3
E. To Shut off the filter, turn the white
handle into the down position on the
diverter valve.
Congratulations! Your system is now
ready for use!

4
FOR CARE & OPTIMAL PERFORMANCE:
1. Let the faucet water run for a few seconds before each operation, as this will extend the
filter life by letting the settled particles get flushed out prior to water entering filter.
2. Flush the system for 2 minutes when it hasn’t been used for 2 or more days.
3. Never run hot water through the filter as the filtration process will not be effective. Use
only cold/cool water. Throughout usage you may notice the water level fluctuate in
the transparent chamber, this is a normal effect and does not interfere with proper filter
function.
4. Filter Cartridge Replacement (For consistently superior water quality):
a. Every 8 months: If using 2-3 gallons (32-48 cups)/day
b. Every 12 months: If using less than 2 gallons (32 cups)/day
We recommend lubricating the black rubber o-rings inside the housingsand on the spout
with anFDA & NSF Compliant Food-Grade Silicone lubricant (Available on our website,
PureEffectFilters.com, in the “Parts” Section) during cartridge changes to help maintain
leak-free performance.
5. Every 6 months (recommended) or during cartridge changes: remove cartridges and
wipe the unit clean inside using Hydrogen Peroxide (do not get hydrogen peroxide inside
the filter cartridges), rinse with warm water, reinsert cartridges and flush with cold water
for 5 minutes.
*We recommend you HAND TIGHTEN the housings closed, so to avoid over
compressing/damaging the rubber o-rings inside, however, to open, use the provided
white wrench. If however, you need to use the wrench to tighten the housings closed,
please take extra care not to over-tighten.
6. If/when you need to disconnect tubing from input elbow:
7. Do not use system if your water pressure is above 75PSI.
*Push in and hold
collet, while
pulling tube out.

5
RETURN / EXCHANGE POLICY
1. If the filter arrived damaged, please call us immediately to get an exchange: 1-347-492-4014.
2. If you choose to return the filter for any reason other than damage upon arrival, we will be happy to issue
a full purchase price refund or exchange within: 14 days of delivery date, minus shipping cost. The
return policy applies to water filter systems and any unused (sealed) filter media cartridges. If
cartridge have been used or shrink wrap has been removed, we will deduct the price of the cartridges from
the refund, as they will no longer be re-sellable.
3. If you decide to return past the 14-day return period, we will still accept the item for up to 30 days
from delivery date, however, there will be a reasonable 10% restocking fee applied. Please call us or send
an email to initiate the return process or if you have any further questions.
Once you’ve experienced your new system, feel free to share your positive experience by going to
our website product page and writing a review. ☺Thank You! -The PureEffect Team
NO-HASSLE 2-YEAR WARRANTY
SURVIVE & PROSPER, INC. dba PureEffectFilters.com, warrants it's water filter systems to be free of
defects in parts and workmanship for a period of: two (2) years from the date of purchase.
All our systems are made of high-quality components (not made in china) and are designed to last for many
years beyond the warranty period, but if any manufacturing defect is present, it will make itself know well
within the warranty period.
In the rare case that it should become necessary to repair or replace the filtration system or one of it's
components, please take a photo of the damaged part and email it along with your order # and a detailed
description of the defect to: [email protected] or contact our Customer Service Department at: 1-
888-891-4821. We will handle your claim promptly, and as hassle-free as possible.
This warranty does not apply to defects resulting from action/s of the user such as: misuse, accidents,
improper installation, operation outside of specification (e.g. over the indicated PSI limit, exposure to direct
sunlight, freezing temps, UV light), improper maintenance or repair and unauthorized modification.
Survive & Prosper, Inc.’s total liability is limited solely to repair or replacement of the product. The
warranty set forth above is inclusive and no other warranty, whether written or oral, is expressed or implied.