PureMate PM1570 User manual

CERAMIC TOWER HEATER
Model No: PM1570

1
SAFETY INSTRUCTIONS
Thank you for purchasing the innovative product the PureMate
ceramic tower heater. We wish you many years of healthy
indoor air and warmth with this efficient and effective product.
Always operate the product from a power source of the
same voltage, frequency and rating as indicated on the
product identification plate.
-
The heater must not be located immediately below a
socket-outlet.
-
Remove the unit from its packaging and check to make sure
it is in good condition before using.
-
Do not let children play with parts of the packing ( such as
plastic bags)
-

2
-
Children of less than 3 years should be kept away unless
continuously supervised.
-
-
Do not operate any product with a damaged cord or plug,
or after the product malfunctions, or is dropped or appears
damaged in any way. Return the complete product to the
place of purchase for inspection, repair or replacement.
-

3
Before unplugging the power cord, be sure to turn the
power off. When touching the unit, be sure your hands are
dry to prevent electrical shock.
-
Ensure the cord is fully extended before use and arrange it
so that it is not in contact with any part of the heater.
-
Switch off and unplug from outlet when not in use, before
assembling or disassembling parts and before cleaning.
Remove by grasping the plug - do not pull on the cord.
-
A common cause of overheating is deposits of dust and fluff
entering the heater. Ensure these deposits are removed
regularly by unplugging the heater, allowing it to cool and
cleaning as described in the Care, Cleaning and Storage
section.
-
Be sure that no other high current appliances are plugged
into the same circuit with your heater as an overload can
occur.
-
Avoid the use of an extension cord as the extension cord
may overheat and cause a risk of fire.
-

4
Do not leave the appliance unattended when switched on.
-
Do not place objects on the product or allow objects to
obstruct the inlet or outlet openings, or operate in close
proximity to walls or curtains, etc. Do not cover the unit when
in operation.
-
Do not locate the heater immediately below a socket-outlet.
-
The use of attachments or accessories not recommended
or sold by the product distributor may cause personal or
property hazards or injuries.
-
Do not use the appliance for other than its intended use.
-
Do not use outdoors. FOR INDOOR USE ONLY.
-

5
This product is intended for normal domestic/household
use only.
-
Use this heater as described in this manual. Any other uses,
not recommended by the manufacturer, may cause fire,
electric shock, or injury to persons and may void the
warranty.
-
The use of attachments or accessories not recommended
or sold by the product distributor may cause personal or
property hazards or injuries.
-
This product is intended for normal domestic/household
use only.
-
Use this heater as described in this manual. Any other uses,
not recommended by the manufacturer, may cause fire,
electric shock, or injury to persons and may void the
warranty.
-
Use only an approved extension cord that is suitable for the
appliance rating!
-
Use only an approved extension cord that is suitable for the
appliance rating!
-

6
Do not lay the cord under a carpet. Do not lay rugs, mats or
similar articles on it. Position the cord so that it does not pose
an obstruction or a tripping hazard.
-
Never pull the plug out of the socket at the cord!
-
Always disconnect the mains plug when the appliance is
not in use.
Attention! The appliance may only be used for normal
domestic use and not for industrial purpose.
-
The appliance should be placed with a minimum distance
of 90 cm away from flammable objects (e.g. curtains), walls
or other structures!
-
Use only an approved extension cord that is suitable for the
appliance rating!
-

7
COMPONENTS
Digital Display
Air Outlet
Base
Touch Control Panel Handle
Wind Inlet
Master Switch
On/Off Heat
Low/High
Timer
Temperature
Increase
Oscillation
Temperature
Decrease
CONTROL PANEL & REMOTE CONTROL
o
C
On/Off
Temperature
Display
Display Light
Low Heat
High Heat
Temperature
Oscillation
Timer

8
BASE ASSEMBLY
Before use, remove all packaging and inspect the
appliance for any damages. If there are appears to be any
damages, please take back to place of purchase for a
replacement.
-
Ensure that all the accessories are included as per diagram
above before you can continue with the installation.
-
Ensure that the location of the heater installed is not directly
under a power socket and that a power socket is available
to power the appliances for use.
-
BEFORE USE

9
OPERATING INSTRUCTIONS
Plug the unit in and turn on the main power switch at the
back of the unit.
Press the Standby button to turn on the unit, this will enter
Low Heat Mode (1300W). Press again to turn off.
Press once to activate High Heat (2000W). Press again to
return to Low Heat (1300W)
Press to increase the desired room temperature
Press to decrease the desired room temperature.
Temperature can be set between 10 - 49°C
-
When the heater has reached the desired set temperature,
the fan mode will continue to blow until the temperature has
dropped to 2°C below the et temperature (the heater will
automatically turn on the low heat setting, if the temperature
drops 4°C below the set temperature the heater will
automatically choose the high heat setting.)
-
Press to activate oscillation. Press again to stop oscillation.
Press until you reach the desired number of hours (up to
8hrs) before you want the heater to turn OFF.

10
After no manual operation after 10 minutes under the working
condition of the product. All functions remain unchanged and
the display turns off. Press any key, including remote control, to
cancel.
DISPLAY LIGHT
WARNING: Before removing the plug from the socket, please
switch off and allow the unit to blow cool for the 30 second
period to protect inner parts.
REMOTE CONTROL BATTERY
The remote control requires 1 CR2025 3V lithium battery (not
included)
Important: Follow the instructions of use and the recycle rules
given on the battery packaging.
Open the battery compartment by sliding the cover down.
-

11
OVERHEAT PROTECTION
This heater is protected with an overheat protection that
switches off the appliance automatically in case of
overheat,e.g. due to the total or partial obstruction of the grids.
In this case, unplug the appliance, wait about 30 minutes for it
to cool and remove the object which is obstructing the grids.
Then switch it back on as described above. The appliance
should operate normally. Should the problem persist, please
con
contact the nearest customer service.
NOTE: To assist in maintaining the internal components, after
pressing the OFF button the fan. Will continue to blow room
air for a period of 30-60 seconds before shutting down to
standby.
Insert the battery into the compartment,
observing the polarity in the diagram (see below drawing).
-
Close the battery compartment.
-

12
SAFETY FEATURES
In the event of abnormal overheating, a safety device shuts
down the appliance automatically. After a short cooling
down phase, the appliance is ready for use again.
-
If you still notice the same defect as above mentioned,
remove the plug from the socket and consult your authorized
dealer to your after-sales service department.
-
During use, do not touch or cover the air outlet. This may
cause the unit to overheat, and the safety device to operate.
-
The unit is also fitted with a tip over switch. Do not use on thick
and long pile carpets, as the heater may not work, due the
tip over switch not been activated.
-
CLEANING & MAINTENANCE
Your appliance must be switch OFF via the main power
supply and unplugged before proceeding with any cleaning
work.
-
Clean the housing with a lightly damp cloth, a vacuum
cleaner or a dusting brush.
-
Never use flammable or abrasive cleaning agents such as
benzene or spirit to clean the appliance.
-
Never immerse the appliance in water!
-
Clean the air inlet and outlet regularly with a vacuum cleaner.
-
If the appliance is not used for an extended period it must be
protected against excessive dust and dirt. Please dismount
the heater and store in a dry place away from sunlight and
dirt.
-

13
SPECIFICATIONS
DISPOSAL OF THIS DEVICE
When the time comes to eliminate this product, please
consider the environmental impact and take it to
recognized recycling facility instead of disposing it with
general household waste. Take the equipment to a
waste disposal site. Plastic and metal parts that are used
in the construction of this appliance can be separated
into pure grade which allow recycling. Ask to your service
cen
center for details. Everyone of us can participate on the
environmental protection.

14
Item
Heat output
Nominal heat
output
Manual heat charge control,
with integrated thermostat
manual heat charge control
with room and/or outdoor
temperature feedback
electronic heat charge control
with room and/or outdoor
temperature feedback
fan assisted heat output
single stage heat output and
no room temperature control
Two or more manual stages,
no room temperature control
with mechanic thermostat
room temperature control
with electronic room
temperature control
electronic room temperature
control plus day timer
electronic room temperature
control plus week timer
room temperature control, with
presence detection
room temperature control, with
open window detection
with distance control option
with adaptive start control
with working time limitation
with black bulb sensor
Contact details
Super Tech Health Ltd, 129 Shady Lane, Great Barr, Birmingham, B44 9ER
United Kingdom
01212709423 [e-mail]
Minimum heat
output
(indicative)
Maximum
continuous
heat output
At nominal
heat output
At minimum
heat output
In standby
mode
Auxiliary electricity
consumption
Item
Type of heat input, for electric storage
local space heaters only (select one)
Type of heat output/room temperature
control (select one)
Other control options
(multiple selections possible)
Symbol
P
nom
P
min
P
max,c
el
max
el
min
el
SB
2,0 KW NA
NA
NA
NA
NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
NO
YES
KW
KW
KW
KW
KW
Value Unit Unit

CERAMIC TOWER HEATER
WWW.PUREMATE.CO.UK
Model No: PM1570