PVI Industries MAXIM 40 P 90A-MXG User manual

Product is patented in the U.S., Canada, and Mexico.
PVI INDUSTRIES, LLC
FORT WORTH, TEXAS 76111
PV 6291 9/07 [phone] •www.pvi.com
MAXIM • PACKAGED GAS WATER HEATER
POLYSHIELD®POLYMER-LINED STORAGE TANK
90 GALLON TANK SERIES
MODEL NUMBER 40 P 90A-MXG 54 P 90A-MXG
GPH Recovery at 40° to 120° F 500 670
GPH Recovery at 40° to 140° F 400 540
Input Btu/h 399,000 540,000
* Minimum inlet flow gas pressure – " W.C. 4.5 4.0
A Cold Inlet - NPT 2 2
B Hot Outlet - NPT 2 2
C Drain - NPT 1 1
D I - Beam Skids 3 x 34-1/2 3 x 34-1/2
F Overall Height 64 72
G Flue Outlet Diameter 7 8
H Gas Inlet - NPT 3/4 1
J Motor HP 120 V, 1Ø, 60 Hz. 1/3 1/3
K Motor Amps 8 8
L Height to Outlet 53 61
M Height to Inlet 28 36
Approx. Shipping Weight - lbs 1010 1130
Recoveries based on 83% thermal efficiency. ASHRAE 90.1 compliant.
Dimensions are in inches unless otherwise specified.
* The information presented is for natural gas 0.6 S.G. – For operation with propane (LP gas), consult the factory.
For standard and optional equipment, see form # PV 6141.
STANDARD GAS PRESSURE REQUIREMENTS:
SEE TABLE FOR MINIMUM PRESSURE BY MODEL NUMBER.
MAXIMUM STATIC INLET GAS PRESSURE: 14" W.C.
FOR GAS PRESSURES OUTSIDE OF THIS RANGE,
CONTACT YOUR PVI REPRESENTATIVE.
STANDARD ELECTRICAL REQUIREMENTS:
CONTROL VOLTAGE: 120V, 1Ø, 60 HZ., 2 AMPS
MOTOR VOLTAGE: 120V, 1Ø, 60 HZ.
SEE ABOVE CHART FOR BLOWER MOTOR AMPS
VENTING REQUIREMENTS:
-.02" TO -.06" W.C. (NEGATIVE PRESSURE).
TYPE B VENTING
THE ENTIRE VENT SYSTEM SHOULD NEVER BE SIZED BASED UPON THE
VENT CONNECTION DIAMETER EXCLUSIVELY.
FOR PROPER VENT SIZING, CONSULT THE NATIONAL FUEL GAS CODE
UNDER "FAN-ASSISTED".
PVI RESERVES THE RIGHT TO CHANGE THE DESIGN AND
SPECIFICATION WITHOUT NOTICE
1. Control Enclosure
2. ASME Temperature &
Pressure Relief Valve
3. 3” NPT Handhole