
PXF Lighting
73 Jutrzenki Street,
02-230 Warsaw, Poland
+48 22 33 44 000, +48 22 33 44 033
Installation manual
Bari II DL 195
230V/50HZ
1. Weight and power
2. Assembly
a) carefully take the luminaire from the packaging
and put on safe surface (table, floor)
b) turn frame from luminaire off and screw reflector off
c) power connection
- take power wire through the hole in the
base of luminaire
- connect wires according to power cube’s scheme
d) assembly the luminaire at the ceiling with spring
e) screw the reflector and assembly lamps
f) in case of IP44 mounting, assembly IP44 glass, which assures tightness at the side of glass
3. Important warnings:
The manufacturer cannot be considered liable for any damages deriving from improper, wrong and
unreasonable use of the fitting.
Luminaries may be installed by qualified personnel only.
Any manipulation inside the luminaire when power supply is on causes the risk of electric shock.
Manufacturer is not responsible for any flaws caused by avoid using this manual.
Manufacturer reserves a right to change the construction of the product.
Do not assembly in places without air circulation.
To guarantee safety of luminaire functions, please assembly according to instruction.
The European Directive 2002/96/EC on waste electrical and electronic equipment, requires that electric and electronic devices must be
disposed of in the normal household waste. The crossed out wheeled bin is reproduced in order to remember obligations towards
separately collection. For correct disposal, please use authorized waste disposal facilities or returned to the distributor at the date a new
lighting fitting is purchased. Lamps, if disposed together with the lighting fitting, shall not be broken up since they contain substances which
are highly polluting for the environment. Unauthorized disposal of the foregoing waste material is punishable by law. More details of
directive available at: http://www.gios.gov.pl