PXF Lighting Presto LED 1145 DI User manual

PXF Lighting
73 Jutrzenki Street
02-230 Warsaw
[phone], [phone]
Installation manual
Presto LED
220-240V/50-60Hz
1. Dimensions and mounting holes
Model
A
[mm]
B
[mm]
C
[mm]
D
[mm]
E
[mm]
F
[mm]
G
[mm]
H
[mm]
I
[mm]
K
[mm]
O
[mm]
Weight
[kg]
1145 DI
125
52
1145
900
880
50
92
80
18
2,0
1145 DI-IN
125
58
1145
900
92
16
18
2,45
1435 DI
125
52
1435
1190
1150
50
92
80
18
2,5
1435 DI-IN
125
58
1435
1190
92
16
18
3,0
2. Installation
a) carefully remove the luminaire from the package and put in on a stable
surface
b) using gloves gently remove louver from the casing
c) PENDANT INSTALLATION screw on simple suspension and mechanical
suspension to the ceiling in the spacing D and G. Fix 4 line regulators into
montage bushes on the back of the luminaire. Slightly loosen outside
regulator nut, slip the line to reach desired suspension length, then tighten
on the nut again. Pulling the wire deeper causes lifting the luminaire up, to
lower it –loosen the nut and press it towards the luminaire –the line will
come out.
SURFACE INSTALLATION place nail anchors in the ceiling according to E x F
spacing, put the luminaire on
d) place the end caps nr. 4 on the ends of luminaire, pull the blocking
element nr. 2, then tighten the screws nr. 3.
e) connect the power supply according to marking on the power connector
f) put the connector of the PE wire on the louver
f) put the louver back on
Light line installation:
Light line assembly is done by sliding the joining kit nr1 in, tilt back the blocking
element nr.2 and adjusting screw nr3.
Next, slide the other luminaire onto the other ends of joining kit and tighten the screws. Connect the plugs or through-wiring together and
connect one of the fittings to the power accordingly to the markings on the connection terminal and the drawing above.
3. Important warnings:
- Luminaires may be installed by qualified and registered personnel only.
- Any manipulation inside the luminaires when the power is activated causes the risk of electrical shock
- The manufacturer is not responsible for any flaws resulting from non-compliance with these instructions
- The manufacturer reserves the right to change the construction of the luminaire
- Do not install the luminaire in places without sufficient air circulation
- To guarantee safe luminaire functioning, please follow the installation instructions
The European Directive 2002/96/EC on waste electrical and electronic equipment, requires that electric and electronic devices must not be
disposed of in the normal household waste. The crossed out wheeled bin is reproduced in order to remind obligations towards separate
collection. For correct disposal, please use authorized waste disposal facilities or return to the distributor at the date a new lighting fitting is
purchased. Lamps, if disposed together with the lighting fitting, shall not be broken up since they contain substances which are highly
polluting to the environment. Unauthorized disposal of the foregoing waste material is punishable by law.

PXF Lighting
73 Jutrzenki Street
02-230 Warsaw
tel.: [phone]
fax: [phone]
www.pxf.pl
PRESTO OPAL /MPRM LED
220-240V / 50-60Hz
POWER (W)
L (mm)
W (mm)
H (mm)
A (mm)
B (mm)
C (mm)
Weight (kg)
31 DI
1145
126
60
900
70
450
3,5
37 DI
1435
126
60
900
70
450
4
43 DI-IN
1145
126
68
960
70
15
4
52 DI-IN
1435
126
68
1200
70
15
4,5
Light source in the fitting cannot be switched or replaced by anyone but manufacturer,
his service representative or similarly qualified personnel.
Important warnings:
The luminaries may be installed by qualified registered personnel only.
Any manipulation inside the luminaire when the power is activated causes the risk of electric shock.
The manufacturer is not responsible for any flaws resulting from non-compliance with these instructions.
The manufacturer reserves the right to change the construction of the product.
Do not install the luminaire in places without sufficient air circulation.
To guarantee safe luminaire functioning, please follow the instructions in the installation instructions.
PXF Lighting website: www.pxf.pl
The European Directive 2002/96/EC on waste electrical and electronic equipment, requires that electric and electronic devices must be
disposed of in the normal household waste. The crossed out wheeled bin is reproduced in order to remind obligations towards separate
collection. For correct disposal, please use authorized waste disposal facilities or return to the distributor at the date a new lighting fitting is
purchased. Lamps, if disposed together with the lighting fitting, shall not be broken up since they contain substances which are highly polluting
to the environment. Unauthorized disposal of the foregoing waste material is punishable by law.
1
2
3
A
INSTALLATION MANUAL