QSP LM-200-R User manual

A
DETAIL A
SCALE 1 : 8
MAST ASSEMBLY
LOW VOLTAGE SWITCH
BATTERIES
1/2-13 X 1" LG
HEX BOLT
INSERT MAST ASSEMBLY INTO BATTERY BOX 1.
MAKING SURE THAT THE LOW VOLTAGE SWITCH
IS FACING THE BATTERIES. MAKE SURE THAT ALL
WIRES ARE FREE AND ARE NOT PINCHED.
BEFORE INSTALLING 1/2" BOLTS MAKE SURE THAT 2.
MAST ASSEMBLY IS COMPLETELY INSERTED IN
BATTERY BOX.
TIGHTEN BOLTS. 3.
B
DETAIL B
SCALE 1 : 8
BATTERY BOX
CASTER SUPPORT
RH & LH
HEX NUT
3/8-16
HEX BOLT
3/8-16 X 1" LG.
ATTACH CASTER SUPPORTS TO BATTERY BOX 1.
USING HARDWARE NOTED.
DO NOT TIGHTEN BOLTS ALL THE WAY AT THIS TIME. 2.
25.437
STEP #1 CASTER
INSTALLATION.
STEP #2 MAST
INSTALLATION
LM-200-R
INSTALLATION AND OPERATION INSTRUCTIONS

C
DETAIL C
SCALE 1 : 8
STEP #3 FORK ATTACHMENT
FORK ASSEMBLY
ROLLER
ALUMINUM
TROLLEY
WHEEL LIFT
SUPPORT
3/8-16 x 3/4"
HEX BOLT
WASHER,LOCK
WASHER
3/8-16 X 7/8"
HEX BOLT
HEX NUT
WASHER
LOCK WASHER
MOUNT WHEEL LIFT SUPPORT TO ALUMINUM 1.
TROLLEY USING HARDWARE NOTED.
ATTACH FORK ASSEMBLY USING HARDWARE NOTED. 2.
1. AFTER CONNECTING WIRES TO THE
BATTERY, ROUTE THE WIRES SO THAT
THEY ARE NOT PINCHED OR
DAMAGED WHILE INSTALLING
BATTERY BOX COVERS.
D
DETAIL D
SCALE1 : 6
FORK ASSEMBLY
MAST
BATTERY BOX
CONNECT
YELLOW/BLACK WIRE
CONNECT
YELLOW/RED WIRE
BLACK JUMPER WIRE -214
STEP #4 CABLE CONNECTION.

E
DETAIL E
SCALE 1 : 5
MAST
REAR VIEW
CHARGER
BRACKET
5/16-18
HEX NUT
5/16-18
HEX BOLT
BOTTOM OF
BRACKET TO
BE INSTALLED
15 1/2" ABOVE
BATTERY BOX.
BATTERY
CHARGER
NOTE:
SLIDE (6) HEX HEAD BOLTS
IN CHANNEL ON REAR OF
MAST. THESE BOLTS WILL BE
USED TO ATTACH CHARGER
BRACKET, TOOL TRAY AND
HANDLE.
G
DETAIL G
SCALE 1 : 7
CONTROL BOX
BATTERY METER
HANDLE
TOOL TRAY
5/16-18 BOLT
AND NUT
UP-DOWN
SWITCH
STEP #5 BATTERY CHARGER INSTALLATION
STEP #6 TOOL TRAY AND HANDLE INSTALLATION.
INSTALL TOOL TRAY AND 1.
HANDLE TO DESIRED HEIGHT.
TIGHTEN ALL FASTENERS. 2.
INSTALL COVERS ON BATTERY BOX. 3.