Quadra-Fire QFI30FB User manual

1
Quadra-Fire • Insert Door Installation Instructions • 2235-912 Rev. F • 4/17
R
Figure 1
Firescreen, Firescreen Leaf, Tuscan Arch and Tudor Panel
Decorative Fronts
Models: QFI30FB, QFI35FB
- Installation Instructions -
INTRODUCTION
The surround is used to ll the space between the insert
and the solid fuel rebox opening. The front is placed onto
the surround after it is attached to the insert.
WARNING! Risk of Fire! Combustible materials MUST
NOT overlap or be placed under a surround.
Combustible Materials Specication
Materials made of or surfaced with wood, compressed
paper, plant bers, plastics, or other material that can ig-
nite and burn, whether ame proofed or not, or plastered
or unplastered shall be considered combustible materials.
CAUTION! Do not install damaged components.
SURROUND INSTALLATION
1. The surround is shipped with the brackets attached for
shipping purposes. Remove the surround brackets from
the surround by removing two screws on each bracket.
2. Mount the left and right surround brackets onto the
appliance with four screws. See Figure 1.
3. Mound the surround to the surround brackets with four
screws. See Figure 1.
4. Attach the surround vanity panel with four 10-24 x 3/4
Phillips pan head screws. See Figure 2.
5. Once the surround is attached, slide the appliance
backward until the surround is tight to the existing non-
combustible nished wall.
Leave this manual with party responsible for use
and operation.
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
DANGER
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and shall be installed for
the protection of children and other at-risk
individuals.
• CAREFULLY SUPERVISE children in same room as
replace.
• Alert children and adults to hazards of high temperatures.
High temperatures may ignite clothing or other
ammable materials.
• Keep clothing, furniture, draperies and other ammable
materials away.
• Do NOT operate with protective barriers open or removed.
• The decorative front must remain closed if children will be
present during the operation of the replace.
• The decorative front may be made operable per these
instructions. This may be done only upon request of
a person responsible for the use and operation of the
replace.
• The decorative front can be returned to the locked position
following these instructions.

Quadra-Fire • Insert Door Installation Instructions • 2235-912 Rev. F • 4/172
Figure 2
INSTALL GLASS VANITY PANEL
Firescreen Leaves, Tudor Panel and Tuscan Arch
Models Only
Firescreen Leaves (FSL-QFI35B):
1. Insert the bottom vanity panel between the glass frame
and the glass at the bottom of the appliance as shown
in 3.
VANITY PANEL
Figure 3. Vanity Panel - Firescreen Front
Tudor Panel (TP-QFI30FB/TP-QFI35FB):
1. Insert the bottom vanity panel between the glass frame
and the glass at the bottom of the appliance as shown
in Figure 4.
VANITY PANEL
DEPTH INDICATORS
Figure 4. Vanity Panel - Tudor Panel Front
BOTTOM VANITY PANEL
TOP VANITY PANEL
A
Tuscan Arch (TA-QFI30FB/TA-QFI35FB):
1. Remove glass assembly per the instructions in the
appliance installation manual.
2. Insert the bottom vanity panel between the glass frame
and the glass at the bottom of the appliance as shown
in Figure 5.
3. Position top vanity panel as shown in Figure 5.
4. Locate the hand bend tabs on left and right sides
indicated in Figure 6. Bend the tabs downward as
shown in Figure 7.
5. Reinstall glass assembly.
Figure 5. Vanity Panel - Tuscan Arch Front

3
Quadra-Fire • Insert Door Installation Instructions • 2235-912 Rev. F • 4/17
HANGING THE DECORATIVE FRONT
1. An extension bracket will need to be installed on the
appliance for proper unit operation. See Figure 8.
2. All fronts mount on the hinges provided with the
surround.
For Inoperable Decorative Fronts:
1. Full width fronts installed in the operable condition pivot
open on the left hinges to access the rebox. If the
child safety mechanism is engaged it will need to be
temporarily removed with a Phillips screwdriver. See
Figure 8.
2. Place the full width fronts onto the hinges by sliding
the decorative front down onto the hinge pins on the
surround.
3. The magnet catch and child safety lock will secure the
decorative front on the right side.
For Operable Decorative Fronts:
1. The operable decorative fronts will use the hinges on
both sides of the surround.
2. Place the left and right decorative fronts onto the
corresponding hinges by sliding the decorative fronts
down onto the surrounds hinge pins.
NOTE: The right decorative front has two magnet catches
and should close last as it is designed to keep the left
decorative front closed.
EXTENSION BRACKET
Figure 8
BEND TAB
Figure 6. Location of Hand Bend Tabs - Tuscan Arch
TAB BENT
Figure 7. Tabs Bent to Secure Vanity Panel - Tuscan Arch

Quadra-Fire • Insert Door Installation Instructions • 2235-912 Rev. F • 4/174
Firescreen, Firescreen Leaf And Tuscan Arch
1. The decorative fronts are shipped with a child safety
lock.
2. After hanging the decorative front on the surround,
place the child safety assembly with the provided
fastener through the hole in the lower right corner of
the decorative front.
3. Shut the decorative front and line up the safety assembly
over the hinge pin.
4. Tighten the fastener with a Phillips screwdriver. See
Figure 10.
5. If the child safety lock assembly is removed, store it in
the extension bracket for future use. See Figure 8.
Figure 10.
CHILD SAFETY LOCK
Tudor Panel
1. The decorative fronts are shipped with a child safety
lock. To lock the decorative fronts, a Phillips screw driver
and a 3/8 in. wrench will be needed. After hanging the
decorative fronts on the surround, place the bolt through
the back of the decorative fronts. The bolt goes through
both decorative fronts in the middle at the top, and is
retained by a nut to prevent them from operating. See
Figure 9.
Figure 9
2. If the bolt and nut used as a child safety lock are
removed, store them in the extension bracket for future
use. See Figure 3.
INSTALLATION OF CHILD SAFETY LOCK
CAUTION! Glass is hot during operation and cool
down. These decorative fronts are supplied from the fac-
tory with parts to lock them shut for child safety.
• To avoid burns or clothing ignition the decorative fronts
must remain closed if children will be present during the
operation and cool down of the replace.
• These decorative fronts may be assembled in locked or
operable condition. They must only be made operable
upon request of a person responsible for the use and
operation of the replace. They may be returned to the
locked position following these instructions.
• These instructions are to be left with a person responsible
for the use and operation of the replace.

5
Quadra-Fire • Insert Door Installation Instructions • 2235-912 Rev. F • 4/17
Service Part List
Quadra-Fire, a brand of Hearth & Home Technologies
7571 215th Street West, Lakeville, MN 55044
www.quadrare.com
Please contact your Quadra-Fire dealer with any
questions or concerns.
For the location of your nearest Quadra-Fire dealer,
please visit www. quadrare.com.
Cleaning Instructions for Decorative Fronts
Use a microber cloth and Windex® Original Glass
Cleaner or 03M003 Stove Bright® Glass Cleaner to
clean the decorative front immediately after installation
to remove acids deposited by the installer or technician.
Spray the cleaner onto the microber cloth and carefully
wipe the entire surface. The decorative front should
be cleaned in this manner annually by the homeowner
to remove ngerprints or other contaminants. Once
oxidation of the paint pigment has occurred, cleaning will
not restore the original color.
SURROUNDS DESCRIPTION PART NUMBER
FBI30-4027-BK, -SB
VANITY PANEL 2201-210FBI30-4230-BK, -SB
FBI304432-BK, -SB
FBI35-4229-BK, -SB
VANITY PANEL 2202-210FBI35-4432-BK, -SB
FBI35-4832-BK, -SB
DECORATIVE FRONTS DESCRIPTION PART NUMBER
TP-QFI30FB-BK, -SB / TPA-QFI30FB-BK, -SB
MESH ASSEMBLY, LEFT 2235-095
MESH ASSEMBLY, RIGHT 2235-096
EXTENSION BRACKET 2235-216
TP-QFI35FB-BK, -SB / TPA-QFI35FB-BK, -SB
MESH ASSEMBLY, LEFT 2237-095
MESH ASSEMBLY, RIGHT 2237-096
EXTENSION BRACKET 2235-216
FS-QFI30FB-BK, -SB EXTENSION BRACKET 2235-216
MESH 2235-012
FS-QFI35FB-BK, -SB EXTENSION BRACKET 2235-216
MESH 2237-012
FSL-QFI30FB-BK, -SB EXTENSION BRACKET 2235-216
MESH 2235-281
FSL-QFI35FB-BK, -SB EXTENSION BRACKET 2235-216
MESH 2237-281
TA-QFI30FB-BK, -SB MESH 2235-224
EXTENSION BRACKET 2235-216
TA-QFI35FB-BK, -SB MESH 2237-224
EXTENSION BRACKET 2235-216