Quidel Lyme FIA Sofia 2 User manual

QuickStart Guide
CUSTOMER SERVICE
If Sofia 2 does not perform as expected, contact Quidel Technical Support 800.874.1517 (in the U.S.),
858.552.1100 (outside the U.S.), technica[email protected] or your local distributor.
Study the User Manual thoroughly before using the QuickStart Guide.
The User Manual can be accessed online at
http://www.quidel.com/immunoassays/sofia-tests-kits/sofia-2-analyzer
A hard copy may also be provided upon request.

UNPACK SOFIA 2
Inspect the shipping container for obvious shipping damage prior to opening.
Unpack the shipping container and inspect the unit for damage.
CONNECT TO POWER AND TURN ON
Place Sofia 2 on the counter top within reach of an electrical outlet. The unit is portable and can be
moved to a suitable location for testing.
Plug the Power Adapter into the power port on the rear
panel of Sofia 2 and appropriate electrical outlet.
Turn Sofia 2 on using the power switch located on the rear
panel. A Power On Self-Test screen will appear on the front
display when Sofia 2 is turned on.
Sofia 2
Power Port
Rechargeable Battery
(pre-installed in Sofia 2)
Power Adapter
Calibration
Cassette
Pouch
Calibration
Cassette
Power Switch
1
2

ENTER ZIP CODE
When prompted, enter the ZIP Code where Sofia 2 is located and select to confirm. Sofia 2 will then
advance to the Run Test screen.
TEST VIRENA CONNECTION
From the Main Menu, select Send Data. Then select Test connection and press to test the Virena
connection.
If the connection is successful, the message Test connection success. Signal strength -##dBm. will
appear. Sofia 2 is now connected to Virena. If the connection is unsuccessful, contact Technical Support.
Continue to Run Calibration.

CUSTOMERS WITHOUT VIRENA ACTIVATED
For Sofia 2 customers without Virena activated, testing the connection will result in the message Send
To Virena Error. Unable to Acquire Cellular Connection. or the Test Connection pop up window could
continue for several minutes requiring the user to restart the instrument. To prevent this message from
reappearing, select Supervisor Menu from the Main Menu. Then select Network Settings, then Virena
Settings. Configure settings to the following:
Press to confirm changes and return to the Run Test screen.

RUN CALIBRATION
Enter the default Supervisor ID of 1234.
Remove Calibration Cassette from the pouch.
Press to advance to the next screen.
Following the prompts, insert the Calibration Cassette into Sofia 2 and gently close the drawer. Sofia 2
will perform the Calibration Check automatically.
The Sofia 2 display will indicate when the Calibration Check is completed.
NOTE: If Calibration Check cannot be completed successfully, notify the on-site Supervisor or contact
Quidel Technical Support for assistance.
Once calibration is complete, remove and return Calibration Cassette to the storage pouch.
Important: Store the Calibration Cassette in the provided storage pouch between uses. Avoid touching
the read window on the Calibration Cassette.
Run QC according to assay specific Package Insert.

MENU STRUCTURE
1330303EN00 (07/18)
Quidel Corporation
San Diego, CA 92121 USA
quidel.com