Quoizel Bain BAN9011K Mounting instructions

Part Description Quantity
A
1 pc.
3 pcs.
Socket Assembly
B
Package Contents
Quoizel, Inc.
6 Corporate Parkway
Goose Creek, SC
29445
Customer Service
Phone [phone]
Fax [phone]
www.quoizel.com
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing
the fixture. We strongly recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool
before removal. Do not subject glass parts to any shock while in operation or shattering may result.
Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2013 QuoizelInc.
A
B
Mounting Screw
Assembly Instruction Sheet #IS-BAN9011K
For Style BAN9011K
1of5
Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire
strippers, electrical tape, safety glasses.
Estimated Assembly Time: 20-30 minutes
Preparation: Identify and inspect all parts before beginning installation. Check package
content list and diagrams below to be sure all parts are present. If any parts are missing
or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer
service for replacement parts.
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
, .
. .
Bulb Recommended: (3) Medium Base 60W Maximum
C
D
C
1 pc.
1 pc.
Finial
D
Cage
E
1 pc.
Water Proof Washer
E
F
3 pcs.
Candle CoverF
June2013

BAN9011K
FINISH: MYSTIC BLACK
1
PART NUMBER
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/2"
REPLACEMENT PART DESCRIPTION REQ.
NO.
2of5
(3) 60W Candelabra
Base Bulb
(Not Supplied)
11”
9.5”
11”
23”
9”
7.5”

Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2013 QuoizelInc.
3of5
Assembly Instruction Sheet #IS-BAN9011K
For Style BAN9011K
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
, .
. .
Figure 1
STEP 1 -Install Candle Cover and Bulb
A. Place the Candle Cover (F) over the Socket as shown.
B. This fixture uses standard bulb with a medium screw
base. Maximum 60 watts.
C. Insert bulb and screw snugly into place.
STEP 2 attach Cage to Socket Assembly-
A. Place Cage (C) and Water Proof Washer (E) over the
Socket Assembly (B), secure by thread Finial (D) onto
the Center Stem on the Socket Assembly (B). Hand
tighten until snug.
Figure 2
Bulb
Socket
Cage
Center Stem
SocketAssembly
Finial
Water Proof Washer
Candle
Cover
June2013

Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2013 QuoizelInc.
4of5
Assembly Instruction Sheet #IS-BAN9011K
For Style BAN9011K
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
, .
. .
STEP 3 Drill Pilot Holes on Post-
A. Carefully fit the Post Fitter over the end of the Post (not
supplied), making sure the Post Fitter is fully seated.
B. Mark the drill point for the (3) Mounting Screws, using
(3) Mounting Holes as reference. After marking hole
locations, remove fixture from post and drill 1/16” pilot
holes for screws.
Post
Figure 3
Post Fitter
Figure 4
STEP 4 Make Wire Connections-
A. Use standard wire connectors to make all wire
connections. (Connectors are not included with fixture.)
Strip and prepare wire ends according to instructions
supplied with connectors.
B. Connect White Supply Wire from the Post to White Wire
from fixture.
C. Connect Black (or Red) Supply Wire from the Post to
Black Wire from fixture.
D. Connect Ground Wire from the Post to Ground Wire from
fixture.
E. Twist connectors until wires are tightly joined together.
F. Wrap each connection with approved electrical tape and
carefully stuff all the connected wires into the Post.
Figure 5
White wire from supply White wire from fixture
Black wire from supply
(or Red)
Black wire from fixture
Ground wire from supply Ground wire from fixture
Post
June2013

Thank you for purchasing a Quoizel product.
Need assistance with parts or assembly? Call Quoizel customer service at 1-631-273-2700
or visit us on-line at www.quoizel.com
2013 QuoizelInc.
5of5
Assembly Instruction Sheet #IS-BAN9011K
For Style BAN9011K
6 CORPORATE PARKWAY
GOOSE CREEK SC 29445
www quoizel com
, .
. .
STEP 5 -Attach Fixture Body to Post
A. Coat the top 1” of the Post with Clear Silicone Caulk
(not supplied) and position the Post Fitter onto the Post.
Be sure to seat it completely, aligning the holes in the
Fitter with the 1/16” Pilot Holes drilled into the Post.
B. Secure the Fixture to Post with (3) Mounting Screws.
Your fixture is now assembled and ready to use.
Enjoy!
Figure 6
Mounting
Hole
Post Fitter
Mounting Screw
Post
June2013