Raidon SR7650-4S-U3D User manual

Version : 1.0 (August, 2008)
SR7650-4S-U3D
SR5650-4S-U3D
GR5800-8S-U3D
Quick Guide

1. Login
1.1 RAIDON SCSI Series Products supports graphic user interface (GUI) to operate the
system. Make sure the network cable is already connected and congured to the same
domain as your current related devices. The following descriptions are examples based
on the default IP address: 192.168.0.1. Please open your web browser and input:
http://192.168.0.1
1.2 To use the system for the rst time, click any of the functions to pop up the dialog window
requesting for account and password. The default account and password are as follows:
Default IP address : 192.168.0.1
Login account : admin
Default Password : 1234
After login, you can choose a function from the list to the left side of the window for related
congures.
1.3 There are four indicators at the top-right corner of the window. Each indicates:
1.3.1 RAID : Green indicates RAID is working properly. Red indicates RAID error.
1.3.2 Temperature : Green indicates normal. Red indicates abnormal system temperature.
1.3.3 Voltage : Green indicates normal. Red indicates abnormal voltage status.
1.3.4 UPS : Green indicates normal. Red indicates abnormal UPS status.

2. Quick Install
You can easily create a volume by using the “Quick install” function. On RAID levels 0, 1, 3,
5 and 6, the system will automatically calculate the maximum available capacity, which is
subject to the number of your hard disks and currently available capacity.
2.1 Select “Quick install” and then select a RAID level. Please refer to the following gure.
After selecting
a RAID level, click “ ” to enter next page to congure
“Bus ID” / “SCSI ID”/“LUN”.
2.2 Select an ID for each device and avoid ID conict in the same SCSI bus. You can change
the volume size in this page. The maximum volume size will be displayed. Please enter a
value less than or equal to that value and then click “ ”.
2.3 Conrmation page. Click “ ” if all the settings are correct. User data
volume created will be displayed.
3. Connect SCSI Cable to SCSI-A or SCSI-B port on the back
panel of SR5650-4S-U3D / GR5800-8S-U3D (users need to
install SCSI adapter on the computer in advance) and proceed
the following process.
4. Initialize Disk
4.1 To format the hard disk, please right-click the “My Computer” icon and then select
“Manage”.

4.2 As shown below, please select “Disk Management”. The unformatted hard disk will
appear (as shown in the red box).
4.3 Right-click the “Disk 1” to pop up three options. Please execute “Initialize Disk”.

4.4 Please select “OK”
4.5 Please select “OK”

4.6 Please select “OK”
4.7 Please select “OK”

4.8 Please select “OK”
4.9 Click “Finish” to complete the process.

4.10 Disk will then be formatted. Once it is completed, the following screen will appear.
Once the disk is formatted, you can start use the system.
NOTE: RAIDON Technology, Inc. only provides technical support and service to those who buy prod
ucts directly from us. For end users or those who do not buy products directly from us, please
contact your distributor for prompt and better responses. If your product is not purchased
directly from RAIDON, please do not contact us since you may not get any reply.
All the product information contained in this manual is the property of
RAIDON Technology, Inc. All rights reserved