Rayrun R722 User manual

2
99 Dynamic Modes
29 Static Colors
Unit Length Adjustable
Static Brightness Adjustable
Speed Adjustable
6
3
4
5
10
+
-
1
2
7
8
9
USER'S MANUAL
Card Type RF Remote
Ultra Slim Design
Loop Demo Mode
Drive up to 800 Pixels
Power off Memorize
1. Power Input
The power supply input.
and sleeve is negative. Also please make sure the power
supply voltage is same as the LED load.
The DC jack’s inner pole is positive
2. Signal Output
The control signal output connector to LED load.
3. Mode Adjust
Adjust running mode. Jump to next mode by press ‘MODE+’ or
jump to previous mode by press ‘MODE-’.
Functions
4. Speed (Brightness) Adjust
Adjust the running speed of dynamic mode or brightness of
static color. There are 10 levels for both speed and brightness.
5. Pause / Play
Toggle between Play and Pause mode. It will quit pause and
start to play if changing the running mode.
6. Turn On / Standby
Turn on or switch to standby mode. The main unit will
memorize the current setting. When power on or turn on unit,
it will automatically restore to previous status.
7. Unit Length (Static Color) Adjust
Adjust playing unit length at dynamic modes or adjust color at
static color mode. At static color mode, press these keys to loop
chang olors.
8. Program direct selecting keys
User can directly select program by the number and Enter key
in this area. For example, if you want program number 58,
please press number 5 and 8, then press Enter key to confirm.
The program ‘0’ is static color mode. At this mode, user can
adjust brightness or color by SPEED and LENGTH keys.
9. Demo Mode
Switch to demo mode. In demo mode, the controller will
automatically cycle play 99 dynamic programs.
10. Remote Controller Indicator
This blue indicator will light up when remote controller works.
In program direct selecting operation, this indicator will flash
slowly until Enter key pressed or no operation for a certain
time.
Hints: The remote controller works at radio frequency, the
signal can pass through barrier, so it’s not necessary to aim at
the controller when operate the remote.
Installing
2. Output Signal
The output signal is in a SM type plug. The cable at the ' '
maker side is power supply, the cable sequence is power-
data-clock-ground. The controll signals are running at high
speed, led may not work properly if the data cable is too
long or get interfered. In This case, please shorten the data
cable from controller to LED or install the controller close to
LED.
1. Power Supply
The power supply jack is a 5.5mm diameter DC socket. The
main unit can work at DC 5V to 24V. Since the power supply is
directly connected to the LED signal output, please make sure
the power voltage is same as the LED load, otherwise the
incorrect voltage may damage LED load!
When LED load is powered individually, the main unit can also
work with the LED load power, and the power supply to this
DC jack can be saved.
e 29 c
www.ledtechnologies.co.uk

45
6
Dynamic Program 99 programs
Dynamic Speed 10 levels
Dynamic Length 16-500
Demo Mode Yes
Static Color 29 colors
Static Brightness 10 levels
Working Voltage DC 5-24V
Driving Capacity 800 pixels
Control mode RF wireless remote
Remote Frequency 433.92MHz
Remote Distance >15 meters at open area
5. Cascading strip installation
This controller can drive up to 800 pixels in series. At series
installation, the power voltage on LED load might drop due to
cable or PCB resistance, the brightness might drop with
increasing of series length. In this case, please add extra
power supply at the point that brightness dropped, to
maintain proper working voltage to whole LED loads.
Remote Pairing
The controller and remote is 1 to 1 paired as default. The
controller only can be controlled by paired remote. When
extra remote is needed or the controller need to be matched
to any remote, user can match the remote by following
combination operation.
1. Pairing a new remote
Do following operation to pair a new remote:
1. Plug off the controller power and plug in again after 10
seconds.
2. Press ‘MODE-’ and ‘LENGTH-’ key at same time in 5 seconds
after power on, then release keys and press ‘MODE+’ key in
another 5 seconds.
The controller can be paired to maximum 5 remotes.
2. Pairing to any remote
Do following operation to accept all same remote:
1. Plug off the controller power and plug in again after 10
seconds.
2. Press ‘MODE-’ and ‘LENGTH-’ key at same time in 5 seconds
after power on, then release keys and press ‘DEMO’ key in
another 5 seconds.
0 Static color 25 Red-purple-red forward
1Full color forward flow 26 Red-purple-red reverse
2 Full color reverse flow 27 Red-purple-red open
3Full color open 28 Red-purple-red close
4Full color close 29 Red-yellow-red forward
5 6-color forward comet 30 Red-yellow-red reverse
6 6-color reverse comet 31 Red-yellow-red open
76-color comet open 32 Red-yellow-red close
8 6-color comet close 33 Green-yellow-green
9 3-color forward comet 34 Green-yellow-green
10 3-color reverse comet 35 Green-yellow-green open
11 3-color comet open 36 Green-yellow-green close
12 3-color comet close 37 Green-cyan-green forward
13 Green sandglass 38 Green-cyan-green reverse
14 Red sandglass 39 Green-cyan-green open
15 Blue sandglass 40 Green-cyan-green close
16 3-color sandglass 41 Blue-purple-blue forward
17 6-color forward flow 42 Blue-purple-blue reverse
18 6-color reverse flow 43 Blue-purple-blue open
19 6-color open 44 Blue-purple-blue close
20 6-color close 45 Blue-cyan-blue forward
21 3-color forward 46 Blue-cyan-blue reverse
22 3-color reverse 47 Blue-cyan-blue open
23 3-color open 48 Blue-cyan-blue close
24 3-color close 49 Blue-white-blue forward
Programs
50 Blue-white-blue reverse 75 6-color sway
51 Blue-white-blue open 76 6-color sway with
52 Blue-white-blue close 77 Blue ground white ping-
53 Red-white-red forward 78 Green ping-pong
54 Red-white-red reverse 79 Green ping-pong with
55 Red-white-red open 80 Red ping-pong
56 Red-white-red close 81 Red ping-pong with
57 Green-white-green 82 Blue ping-pong
58 Green-white-green 83 Blue ping-pong with
59 Green-white-green open 84 3-color ping-pong with
60 Green-white-green close 85 6-color ping-pong with
61 Green sway 86 Green drop
62 Green sway with 87 Green drop with ground
63 Red sway 88 Red drop
64 Red sway with grounding 89 Red drop with ground
65 Blue sway 90 Blue drop
66 Blue sway with 91 Blue drop with ground
67 Yellow sway 92 Blue ground white drop
68 Yellow sway with 93 Red ground white drop
69 Purple sway 94 Green ground white drop
70 Purple sway with 95 3-color drop
71 Cyan sway 96 6-color drop
72 Cyan sway with 97 3-color sway
73 3-color sway 98 6-color sway
74 3-color sway with 99 6-color jump
Specification