Razor HOVERTRAX 2.0 Use and care manual

Calibration Confirmation
Note: Your Hovertrax 2.0 should have been calibrated at the factory.
1 Place Hovertrax 2.0 on a level surface.
2 Turn power ON. If product remains level or adjusts to become
level, calibration has been confirmed. No further steps are needed.
If product begins to roll or does not move into a level orientation,
see Calibrating Hovertrax 2.0 on page 2.
Need Help? Visit our web site at www.razor.com or call 1800 244 543 or email:
[email protected] Monday - Friday 9:00 AM - 5:30 PM.
HOVERTRAX 2.0/DLX 2.0
CALIBRATION INSTRUCTIONS
1

Calibrating Hovertrax 2.0
3 While keeping the product level, turn power ON and HOLD until
product beeps and lights flash (approximately 15-20 seconds).
2 Manually adjust the platforms so they are level to the ground.
1 Place Hovertrax 2.0 on a level surface.
Need Help? Visit our web site at www.razor.com or call 1800 244 543 or
email: [email protected] Monday - Friday 9:00 AM - 5:30 PM.
HOVERTRAX 2.0/DLX 2.0
CALIBRATION INSTRUCTIONS
2

Calibrating Hovertrax 2.0
4 Turn power back OFF.
5 Calibration complete.
Note: Once the product has been calibrated, no matter what
position (angle) the platforms are in when it is turned off, the
platforms will automatically self-balance themselves back to the
calibrated position when product is turned on.
Need Help? Visit our web site at www.razor.com or call 1800 244 543 or email:
[email protected] Monday - Friday 9:00 AM - 5:30 PM.
HOVERTRAX 2.0/DLX 2.0
CALIBRATION INSTRUCTIONS
3
161216