Razor POWER A 2 User manual

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. Phillips screwdriver
B. Small Flat screwdriver
C. Long needle nose pliers
D. 3 mm Allen wrench
E. 5 mm Allen wrench
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a Phillips screwdriver, remove the screw located at
the very front of the deck and pull the deck cover off from
the deck.
Disconnect the throttle cable from the controller.
POWER A2
QUICK RELEASE / STEM
REPLACEMENT PROCEDURES
PART # W13113202032

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3 Step 4
Using a small flat screwdriver, remove the grommet
inside the opening of the deck.
Using a smal flat screwdriver, remove the C ring from the
folding mechanism pin. Slide the pin out from the frame.
Unfold the unit. Using a pair of long needle nose pliers,
remove the spring from the folding mechanism pin.
Using a 3 mm Allen wrench, remove the set screw at the
back of the folding knob while holding the knob.
Step 5 Step 6

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
3
Step 7 Step 8
Unscrew and remove the knob. Slide down the plastic
block of the folding mechanism.
Using a 5 mm Allen wrench, loosen the bolt from the
collar clamp and remove the stem from the fork.
Set aside all the parts from the folding mechanism.
Open the quick release.
Step 9 Step 10

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
4
Step 13
Reverse the steps.
ATTENTION: Charge battery 8 hours before using.
Using a 3 mm Allen wrench, loosen the screw from the
quick release.
Slide the quick release up from the stem and replace it.
Step 11 Step 12