rba RBA7730-003 Manual

INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY |MELBOURNE | BRISBANE | PERTH | AUCKLAND
Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz
4
Note: This product should be installed, by suitably qualied persons, in a t for purpose application, to suitable
materials, using suitable xings and comply with any relevant codes. It should be inspected periodically for signs
of wear and tear that may affect performance or safety.
Dimensions are subject to manufacturer’s tolerance of +/-10mm. Rough-in should be completed with each
xture.
Important: Installation Instructions are subject to change without notice. Please visit www.rba.com.au for latest
revision.
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY |MELBOURNE | BRISBANE | PERTH | AUCKLAND
Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz 1
RBA7730-003 Wall Mounted Gel Sanitiser & Soap Dispenser
RBA7730-004 Wall Mounted Gel Sanitiser & Soap Dispenser with Drip Tray
RBA7730-005 Gel Sanitiser & Soap Dispenser with Drip Tray & Stand
RBA7730-013 Wall Mounted Spray Sanitiser & Soap Dispenser
RBA7730-014 Wall Mounted Spray Sanitiser & Soap Dispenser with Drip Tray
RBA7730-015 Spray Sanitiser & Soap Dispenser with Drip Tray & Stand
Date
14/08/20
Model
Sanitiser Dispenser
Supercedes all previous
Sourced/ Supplied under QMS

INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY |MELBOURNE | BRISBANE | PERTH | AUCKLAND
Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz
2
Packing List
4 x C batteries not included
1.
2.
*Remove bottle and pump
assesmbly to rell
*Ensure pump & bottle are properly
replaced after relling
***For Battery recycling options in your area visit https://recyclingnearyou.com.au/
INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS
SYDNEY |MELBOURNE | BRISBANE | PERTH | AUCKLAND
Australia 1300 788 778 www.rba.com.au | New Zealand 0800 722 111 www.rbagroup.co.nz 3
Installation
Use screw xings provided.
If electing to use double sided tape [by others] to x to wall, RBA7730-999-006 Drip Tray cannot be
installed as unit will sit too far off the wall.
If installing to meet AS1428.1-2009 in a bathroom, ensure outlet of dispenser is 900-1100mm off the FFL
and compliant with all other aspects of the code.
Avoid excess humidity, reective surfaces and direct sunlight when installing.
Allow 400mm bench clearance under the dispenser
The installer/owner should assess of the potential risk of sanitiser being ingested by children and locate the
dispenser at an appropriate height and/or a supervised location.
Operation
Hold hand under dispenser for sensor operation. Do not remove hand until dispense operation is complete.
To rell bottle and/or clean inside unit, turn unit off and remove bottle assembly to avoid spillage Do not use
>75% alcohol sanitiser
Maintenance
Turn unit off and wipe with a damp cloth. Soft detergents can be used if necessary. Do not use bleach-
based or abrasive cleaning chemical.
Periodically clean the dispenser by pumping warm water through the unit
Indicator Light:
Green 5 Second Flash - Normal Operation
Red 5 Seconds Flash - Low Battery
Red 2 Second Flash - Obstructed Sensor
TroubleShooting
Problem Probable Cause Solution
Unusual activation Direct sunlight/ Highly reective
surface
Remove Direct/Bright light
Soap / Sanitiser does not
dispense
Batteries are loose or expired Ensure correct battery installation
Replace batteries
Soap/Sanitiser bottle is empty Rell
Sensor is obstructed Remove obstruction
Blocked/Clogged nozzle Incorrect Sanitiser being used Conrm the viscosity of sanitiser suits the type
of pump
Spare Parts
RBA7730-999-006 Drip Tray Kit
RBA7730-999-007 Stand Kit
RBA7730-999-008 Replacement Bottle
RBA7730-999-009 Replacement Pump - Spray
RBA7730-999-010 Replacement Pump - Foam
RBA7730-999-011 Replacement Pump - Liquid/Gel