RC4WD BEAST II User manual

i
Recommended Tools
Modeling/Craft Knife Hex Driver (1.25mm)
Hex Drivers (1.5mm, 2.0mm, 2.5mm)
Side Cutters Styrene Glue
Cross Wrench (M4)
Thread Lock
Cross Head Screwdriver (Small) Long Nose Pliers
Tips for Assembly
Use Acrylic Lacquer or Enamel if you'd like to paint the body parts. Test fit parts before applying
glue and use glue sparingly.
Use good quality hex drivers to avoid stripping screw heads.
Use thread lock when installing metal parts together with metal parts. Do not use instant adhesive.

ii
RC4WD Limited Warranty
All RC4WD products are warranted to be free of defects in materials and workmanship when new.
Our limited warranty does not cover damages due to normal wear and tear, user error of assembly or
installation, user modifications, user's failure to perform routine maintenance, addition of aftermarket
parts or option parts. This warranty lasts 30 days after arrival for original purchaser. In the event of a
defect under this warranty, RC4WD will, at our discretion, replace the product, provided our inspection
indicates that an original defect exists. RC4WD reserves the right to replace any product which is no
longer available with a product of comparable value and function. If RC4WD determines the repair
is not covered under warranty guidelines, we will contact you to discuss your options. If you have any
questions, please contact us via email at [email protected].
Important Notes - General
This truck is suitable for people over the age of 16.
Read carefully and fully understand the instructions before commencing assembly.
When using tools and handing the small parts, extra care should be taken to avoid personal injury.
Take care when building, as some parts may have sharp edges.
Read and follow instructions supplied with paints and / or cement, if used (not included in KIT Version).
Follow the operating instructions for radio equipment at all times.
Keep the wheels of the model off the ground when checking operation of the radio equipment. Never
disassemble battery or cut battery cables.
Please read the instruction manual before you begin.
CONTENTS
RTR Steps: Page iii – vi
Electronic Steps: Page vi – ix
XR4 Radio: Page x – xi
Items List: Page xii – xxix
Body Installation Steps: Page 1 – 23
Kit Installation Steps: Page 1 – 53
Optional Parts: Page 57 – 58

iii
Z-S1527-2
Z-S1227
Z-S1527-2
RTR Step 1
RTR Step 2
Z-S1518
Z-S1529-3
M2X6 Flat Head
Z-S1227
M2.5X8 Button Head
Z-S1518

iv
Z-S0652
M3 Nut
Z-B0091-8
Z-S0652
Z-S0629
RTR Step 3
RTR Step 4
Z-S0629
M3X8 Button Head