Application
•
Hook onto mini-split mounting plate to hold mini-split
unit securely in place while installing refrigerant lines, condensate
line and electrical hookup.
User Instructions
•
1.Attach Mounting Hooks of Mighty Bracket to the
mini-split mounting plate tabs. (If no tabs are present on the mounting
plate, Mighty Bracket hooks can be attached by screws threaded into the
wall stud.) 2. Place Foot Supports at against the wall. (If necessary to
avoid potential wall scratching, place clean towel or cardboard between
support foot and wall surface) 3. Position Level Adjustment Pins to make
Support Arm of the brackets horizontal. 4. Lift Gates at the end of Support
Arms to make sure the unit cannot slide off. 5. Place protective Sleeve
Socks over Gates to avoid scratching the unit. 6. Set unit securely onto
the top of the Support Arms. 7. Connect refrigerant lines using RectorSeal
NoKink™.* 8. Connect condensate drain piping and electrical wiring.
9.Carefully lift and place the indoor unit onto top tabs of mounting plate.
10. While ensuring unit does not fall, carefully remove Mighty Bracket and
installationiscomplete.
Code Description Qty.
97705 Mini-split support tool 4
FEATURES
• Allows single person installation
• Simple clip on support
• Does not damage walls.
• Use on all brands of mini-splits
Mighty Bracket Mini-split installation support tool
MOUNTING HOOK
SUPPORT ARM
MOUNTING PLATE TAB
TYPICAL MINI-SPLIT MOUNTING PLATE
FOOT SUPPORT
LEVEL ADJUSTMENT PIN
SLEEVE SOCK
GATE
1
2
3
4
6
5
Note: When installing the
DMSS indoor unit’s mounting
plate, ensure that the correct
hardware is used. If hung on
drywall, it is recommended
to attach the plate to a stud,
making certain that the tab
area is securely attached to
the wall. Add more screws
around mounting plate tabs
for heavy units. Always install
mounting plate according to
the manufacturer’s published
instructions.
Warning: Bracket not to be
used for weight above 100
pounds.
* When paired with RectorSeal NoKink™ Mighty Bracket™ allows simple installation without damaging or kinking copper refrigerant lines.
RectorSeal Australia PTY. Ltd. • PO Box 3119 DC Clontarf QLD 4019 • 07 3267 7277 • rectorseal.com.au
A CSW Industrials Company. RectorSeal, the logos and other trademarks are property of RectorSeal, LLC, its afliates or its licensors and are protected by copyright,
trademark and other intellectual property laws, and may not be used without permission. RectorSeal reserves the right to change specications without prior notice.
©2018 RectorSeal. All rights reserved. R50304AU-0818
