
PAGE 2 (TWO - INSIDE DPS)
110V Slimline Floodlights
Product Codes: FLAC50Y, FLAC100Y, FLAC150Y & FLAC200Y
Box Contents -
1 x 110V Slimline Floodlight
Dimensions:
FLAC50Y: L: 205 x W: 165 x D: 33mm
FLAC100Y: L: 290 x W: 230 x D: 41mm
FLAC150Y: L: 330 x W: 270 x D: 47mm
FLAC200Y: L: 390 x W: 330 x D: 47mm
Material: Die-Cast Aluminium Body & Glass Lens
Working
Temperature: Standard: -20°C - 45°C
Included: 360° Bracket
Pre-wired 1m Cable
Safety Warning
• The installation should be carried out
by a qualied electrician in compliance
with the current edition of the IEE
Wiring Regulations.
• Prior to installation, carry out the
necessary risk assessment considering
the people who could be at risk,
the level of risk and the precautions
required to control the risk
• Ensure that the circuit supply is
isolated either by the circuit supply
fuse being removed or the applicable
circuit breaker being turned o before
installation or any maintenance.
• Check the total load on the circuit
ensuring the luminaire does not exceed
the rating of the circuit cable, fuse or
circuit breaker.
• Long-term use and voltage uctuations
can reduce the life span of the tting.
• If the tting incorporates control gear,
ensure careful sizing to avoid instances
of nuisance tripping of the protective
device used in the installation.
• Follow the provided installation
instructions, using the xings supplied
or recommended.
• Keep out of reach of children.
110V IP65 2
YRS
GUARANTEE
INSTALLATION INSTRUCTIONS
IK07
Specication
50-
200
WATT
LED 6500K
4750-
19,000LM
1. Ensure there is adequate free air circulation of at least 100mm around the tting. All ttings run hot. It is the installer’s responsibility to consider any re
risk and take appropriate precautions.
2. The nearest illuminated surface must be at least 0.5m from the front of the tting.
3. Check for concealed cables before drilling any xing holes.
4. Unscrew the side xing bolts and remove the mounting bracket from the oodlight.
5. Position and x the mounting bracket to a suitable solid surface using the appropriate screws and wall plugs, sucient to support the weight of the
oodlight.
6. Replace the main body of the oodlight and secure it to the installed bracket using the side xing bolts.
7. The oodlight is supplied pre-wired with 1m of cable. The cable should be installed with an aduequate‘drip loop’to prevent ingress of moisture through
the cable gland. Care should be taken so that cables are not trapped between the mounting bracket and the oodlight.
8. Connect the oodlight to the mains supply with a suitable junction box enclosure or connection tting, making sure that any exposed connections and
joints are suciently weatherproofed.
9. Make the electrical connections as follows, observing the correct polarity:
LIVE (L) BROWN to terminal marked L
NEUTRAL (N) BLUE to terminal marked N
EARTH ( ) GREEN/YELLOW to terminal marked
WARNING - THIS FITTING MUST BE EARTHED
10. Ensure that there are no exposed conductors, loose or trapped cable strands.
11. Switch on the power supply and test the installation for satisfactory operation.
Installation Instructions
Lmm