Red Arrow FLSMD50Y-1 User manual

PAGE 2 (TWO - INSIDE DPS)
FLSMD Site Flood Multi-voltage
Product Codes: FLSMD50Y1, FLSMD100Y1, FLSMD150Y1,
FLSMD200Y1
Box Contents -
1 x LED SMD Yellow Floodlight
Dimensions:
FLSMD50Y-1: L: 310 x W: 310 x D: 65mm
FLSMD100Y-1: L: 320 x W: 320 x D: 90mm
FLSMD150Y-1: L: 365 x W: 370 x D: 94mm
FLSMD200Y-1: L: 425 x W: 410 x D: 110mm
Material: Body: Die-Cast Aluminium
Lens: Tempered Glass
Colour
Temperature: 6500k
CRI: Ra70
LED Lifetime: 35,000 Hrs
Beam Angle: 120° Symmetrical
IP Rating: IP65
Ik Rating: IK07
Working
Temperature: -20°C - 40°C
Power Factor: 0.9
Guarantee: 3 Years
Safety Warning
• The installation should be carried out
by a qualied electrician in compliance
with the current edition of the IEE
Wiring Regulations.
• Prior to installation, carry out the
necessary risk assessment considering
the people who could be at risk,
the level of risk and the precautions
required to control the risk
• Ensure that the circuit supply is
isolated either by the circuit supply
fuse being removed or the applicable
circuit breaker being turned o before
installation or any maintenance.
• Check the total load on the circuit
ensuring the luminaire does not exceed
the rating of the circuit cable, fuse or
circuit breaker.
• Long-term use and voltage uctuations
can reduce the life span of the tting.
• If the tting incorporates control gear,
ensure careful sizing to avoid instances
of nuisance tripping of the protective
device used in the installation.
• Follow the provided installation
instructions, using the xings supplied
or recommended.
• Keep out of reach of children.
86-
264V
IP65
3
YRS
GUARANTEE
INSTALLATION INSTRUCTIONS
IK07
PAGE 1 (FRONT PAGE)
Specication
50-
200
WATT
LED
6500K
W mm
L mm
D mm

PAGE 2 (TWO - INSIDE DPS) PAGE 1 (FRONT PAGE)
1. Ensure there is adequate free air circulation of at least 100mm around the luminaire. All luminaires run hot. It is the installer’s responsibility to consider any
re risks and take appropriate precautions.
2. The nearest illuminated surface must be at least 0.5m from the front of the tting.
3. Do not use if the glass is broken. Replace the luminaire
4. Select an appropriate mounting position. Drill holes for xing at spacing corresponding to the holes on the ttings bracket..
5. Fix the bracket to the wall or similar hard surface with suitable xings (not included).
6. Connect the cable correctly to the supply, observing the colour-coding shown below. Ensure all electrical connections are tight with no loose strands.
Installation Instructions
• Please note this is an IP65 rated product, take care not to break any seals as this will aect it’s water resistant rating.
• Do not modify this product. Any modication to this tting will void the warranty.
• Red Arrow will not take any responsibility for any product damages caused by mounting procedures which are not in accordance with these instructions.
• These ttings comply to CE and UKCA standards.
• Powder coated nish
Additional Information
L = Brown
= Green/ Yellow
N = Blue
INS/SITE/0010/FLSMD-1/V2
T: 0800 195 0006
[e-mail]
Red Arrow Electrical Distribution
Cortonwood Drive, Brampton,
Barnsley, S73 0UF
redarrowelectrical.co.uk
This product is guaranteed for a period of 3 years from the date of purchase. The guarantee is invalid in the case of improper use, tampering, removal of the Q.C.
date label, installation in an improper working environment or installation not according to the current edition of the I.E.E. Wiring Regulations (BS7671). The
guarantee is also invalidated if the luminaire has been insulation tested. Should this product fail during the guarantee period it will be replaced free of charge,
subject to correct installation and return of the faulty unit. We do not accept responsibility for any installation costs associated with the replacement of this
product. Your statutory rights are not aected. We reserve the right to alter specications without prior notice.
• This tting will require routine cleaning if used in adverse (dust, paint, welding, oils etc) environments. Do not use solvents, aggressive detergents or
abrasives.
• The light source & driver in this luminaire can be replaced at end of life. This should be carried out by a competent person. Contact Red Arrow for details of
replacements.
Guarantee
Maintenance
• When this tting comes to the end of it’s life or you choose to replace it, please do not dispose of it with your normal waste. Please recycle where the
facilities exist, check with your local authority for suitable options.