Regency Fireplace Products GF40 User manual

Pellet Stoves & Inserts
Pellet Stoves & Inserts
GF40 Greenfire Pellet Stove
These dimensions are minimum clearances but it is recommended
that you ensure sufficient room for servicing, routine cleaning and
maintenance.
A. Side wall to unit 8 inches (200 mm)
B. Back wall to unit 5.5 inches (140 mm)
C. Back wall to Chimney Connector 4 inches (100 mm)
D. Corner to unit 3 inches (75 mm)
E. Glass to Hearth Pad 6 inches (150 mm)
CLEARANCES TO COMBUSTIBLES

Pellet Stoves & Inserts
Pellet Stoves & Inserts
ALCOVE CLEARANCES
The unit may be installed in an alcove if desired. These minimum
clearances to combustibles must be maintained at all times. Be sure
to leave room for servicing, routine cleaning, and maintenance. These
are inside dimensions.
Minimum Alcove Width 36 inches (915 mm)
Minimum Alcove Height 48 inches (1220 mm)
Minimum Alcove Depth 30 inches (762 mm)
MOBILE HOME INSTALLATION
● Secure the heater to the floor using the two holes in the base.
● Ensure the unit is electrically grounded to the chassis of your
home (permanently).
● Do not install in a room people sleep in.
● Outside fresh air is mandatory. Secure outside air connections
directly to fresh air intake pipe and secure with three screws
evenly spaced.
CAUTION: THE STRUCTURAL INTEGRITY OF THE
MANUFACTURED HOME FLOOR, WALL AND
CEILING/ROOF MUST BE MAINTAINED.
GF40
1
/ 4 ” Lag Bolts
Securely Fastened
Ground Wire Directly
to Metal Chassis
Hearth Pad
Flooring
Steel Frame
EXHAUST
Base of unit to center of flue 10 in (251 mm)
Center of unit to center of flue 0 in (0 mm)
[at center of unit]
FRESH AIR INTAKE
Base of unit to center of intake 6 in (153 mm)
Center of unit to center of intake 2-1/4 in (53 mm)
IMPORTANT: When attaching the exhaust venting system to the unit
or when joining vent sections three screw must be used at each joint.
If vented horizontally, joints shall be made gas tight with aluminum foil
duct tape. Heights may change if leveling legs are adjusted.
EXHAUST AND FRESH AIR
INTAKE LOCATION
OUTSIDE FRESH AIR CONNECTION
Outside fresh air is mandatory when installing this unit in airtight
homes (R2000) and mobile homes.
A Fresh-air intake is strongly recommended for all installations.
Failure to install a fresh air intake may result in improper combustion
as well as the unit smoking during power failures.
When connecting to an outside fresh air source, do not use plastic or
combustible pipe. A 2” minimum (51 mm) ID (inside diameter) steel,
aluminum or copper pipe should be used. It is recommended, when
you are installing a fresh air system, to keep the number of bends in
the pipe to a minimum.
2" ID
(51 mm)
Optional
Elbow
Outside
Wall
GF40 Wood Pellet Stove