Regency Classic F1100 User manual

200 June 2007 Regency Product Specifications Book
Wood Stoves
Wood Stoves
F1100 Small Stove
Residential Installation “C” Vent (Single Wall)
Unit From Unit From Corner From Vent
centerline
F1100 A B C D E F
with Airmate 13” 11” 8” 25” 17.5” 20”
with Rear Deflector 15” 10.5” 11” 27” 17” 23”
Minimum Clearance To Combustible
Materials
Please read the section below carefully as clearances depend on whether
the airmate or the rear heat deflector is installed on the stove.
Measurements "From Unit" are from the top plate of the stove to a side
wall or to a corner, and from the rear heat shield to a back wall.
F1100 Wood Stove

201June 2007 Regency Product Specifications Book
Wood Stoves
Wood Stoves
Residential Close Clearance (To be installed with required pipe components)
When the stove is installed as a close clearance residential unit, a listed double wall connector is required
from the stove collar to the ceiling level.
Unit From Unit From Corner From Vent
centerline
F1100 A B C D E F
with Airmate 9” 5” 3” 21” 11.5” 15”
with Rear Deflector 13.5” 5” 5” 25.5” 11.5” 17”
Mobile Home Close Clearance (To be installed with required pipe components)
“C” Vent single wall pipe is not approved for Mobile Home installations. (Refer to mobile home instructions.)
Unit From Unit From Corner From Vent
centerline
F1100 A B C D E F
with Airmate 11” 6” 6” 23” 12.5” 18”
with Rear Deflector 13” 5” 9” 25” 11.5” 21”
Unit From Unit From Vent
centerline
Min.
Width
Min. Hearth
to Rear Wall
F1100 G H I J K L
with Airmate 11” 7” 23” 13.5” 46” 39”
with Rear Deflector 13” 5” 25” 11.5” 50” 37”
Minimum Alcove Clearance To
Combustible Materials
Regency Freestanding models have been alcove approved and must be
installed with a listed double wall connector to the ceiling level.
Note: Minimum alcove ceiling height - 84"
Maximum depth of alcove - 36"
*The rear clearance to combustibles is less than 6" (152mm), for corner
installations the rear corners may be angled to take advantage of the
closer clearances.
NOTE: In Canada, floor protection must extend 18" to the front
and 8" to each side of the stove.
Floor Protection
A combustible floor must be protected by a non-combustible material
(like tile, concrete board, or certified to UL-1618 or as defined by local
codes) extending beneath the heater and a minimum of 6" from each
side and minimum 16" from the front face of the stove and minimum 6"
(or the rear clearance to combustibles whichever is smaller) from the
rear of the stove.
Minimum Overall Width (X) of Floor
Protector for all installations:
Small Stove F1100S 36"
Minimum Overall Depth (Y) of Floor Protector
Unit Residential
“C” Vent
Residential
Close
Clearance
Mobile
Home Close
Clearance
Alcove
F1100 Y Z Y Z Y Z Y Z
with Airmate 38” 6” 37”* 5” 38” 6” 38” 6”
with Rear Deflector 38” 6” 37”* 5” 37”* 5” 37”* 5”
F1100 Wood Stove