Regent Plato Wall User manual

ELECTRIC SHOCK
HAZARD
This equipment is to be
serviced by trained
personnel only.
Plato Wall
Installation instruction
3 - 13 MAIN REEF SERVICE ROAD, CORNER SPRINGBOK AND MAIN REEF ROAD,
INDUSTRIA, JOHANNESBURG. SOUTH AFRICA.
TEL : [phone]
www.regentlight.co.za
REGENT LIGHTING A DIVISION OF WAHL INDUSTRIES
ALL CONNECTIONS TO B CA D BY A QUALIFIED ELECTRICIANE RRIE OUT
PLEASE READ CAREFULLY BEFORE STARTING INSTALLATION.
Electronic Control Device
WARNING
ŸThis product could be HAZARDOUS if not used correctly, it could cause electric shock, serious bodily harm or death.
ŸThis product is not a toy, please keep away from children.
ŸAny modifications of this product after supply will result in the guarantee being void.
ŸSpare parts may become unavailable over time. Items can vary slightly from the picture on the carton.
ŸCoastal humidity can affect the longevity of the light fitting over time.
ŸBe sure to follow the steps in the order given.
ŸThis product may contain small parts that can be swallowed.
ŸThis product requires a constant stable electrical supply 220V - 240V VAC 50Hz - alternating current.
ŸUse only the correct light bulbs/LED as stipulated on the carton for the product.
ŸThe product must be regularly maintained, including the replacement of lamps/LED timeously.
Important safety instructions
ŸThis product should be installed by a competent person i.e. Qualified electrician.
ŸBe sure to follow the steps in the order given.
Surface Mount

Plato Wall
Installation instruction
Surface Mount
3 - 13 MAIN REEF SERVICE ROAD, CORNER SPRINGBOK AND MAIN REEF ROAD,
INDUSTRIA, JOHANNESBURG. SOUTH AFRICA.
TEL : [phone]
www.regentlight.co.za
REGENT LIGHTING A DIVISION OF WAHL INDUSTRIES
Mark and drill mounting holes to
x wall assembly to the wall.
Ensure the wall assembly is level
before marking positions.
Connect electrical power to the
main supply.
Tighten xing screws to secure
wall assembly to the wall.
Reassemble the luminaire by
tightening the 2 grub screws to
secure the cover to the wall
assembly.
Test the Luminaire.
Remove front face from the
assembled luminaire. Unscrew
one grub screw from either side
until cover comes loose from wall
assembly.
1
2
3
4
Light direction