
Congratulations on the purchase of your new G4 Aluminium Wheelchair.
Equipped with several features and accessory choices, you are sure to enjoy
the benefits of this chair.
Please follow these simple steps to assemble your wheelchair –
1. With the chair upright, push down on the sides of the seat until it
clamps into position.
2. Height adjustable canes can be adjusted for the individual career by
loosening the screws at the base of the cane, adjust and retighting.
3. Backrest is tension adjustable to suit each individual, these are
adjusted by removing the cover and adjusting the velcro tension
straps. Replace the cover and secure the velcro.
4. The G4 also offers a recline backrest, this is adjusted by pulling the
strap at the rear where the backrest and seat meet, ensure it clicks
securely into place at the desired angle.
5. Fit legrests (both left and right) into the fitting from an outward angle
and turning inward until it locks into position. Footplate height can
be adjusted using the allen key provided. Loosen the footplate and
select the desired height, retighten to secure. Elevating legrest are
available for this chair and fit into place the same way as the
standard legrests. To adjust loosen the screw, select the desired
angle and retighten.
6. G4 Self Propel Wheelchairs have a quick release 24” wheel. To
release push the centre button on the axle and pull out. To reinstate
locate the axle back into bracket on the frame. Ensure it is fully
engaged before using the chair.
7. Armrests flip back and are removeable, height and depth adjustable.
To release the armrest push the clip at the front and flip back, to re-
instate clip back into the front bracket and ensure it locks into place.
To remove armrest push clip at the front and pull lever at the rear
then lift armrest out. Again ensure clipped back in securely when
replacing. To adjust height and depth of armrest pad press the
relevant release button and lift or slide to desired position.
8. Care-assist hand brake, (where fitted) provides added security for the
person pushing the chair. When the wheelchair is stationary, the
hand brake at the wheel should be applied for added security. To
apply wheel brake push forward, to release pull back.