Remaco SAS-1515 User manual

M6
Countersunk
Screws
M5 Stopper
Screws
M6 Anchors
M6 Long Nuts
For Suspension from Ceiling
Insert these accessories in
between the indicated arrow.
(optional)
Universal
Bracket
Screen Width
Lanyard
Installation Guide (For SAS-1515 to SAS-2424)
CCOPYRIGHTS 1998 REMACO TECHNOLOGIES PTE LTD Website: www.remacotech.com
V: 4.0
Universal Bracket can be used for any type of installation as shown below.
SAS
Wall Mount
Ceiling Mount Ceiling
Suspension
Pelmet Mount
Ceiling
Recessed
Corner Mount Extension Mount (Wall)
AVA-Wall Ext/L - 25.0cm
AVA-Wall Ext/S - 12.5cm
* For details dimension , please refer to technical specifications at
www.remacotech.com

Screen Frame
Universal Bracket
27 Power Drill
Pin Punch
Hammer
M6 Anchor
B) Drill Dia.8mm Holes to a depth 27mm. C) Insert M6 Anchor into the hole.
D) Use pin punch to expand the anchor.
A) Mark the bracket position with the help of universal bracket.
STEP 1
STEP 2
8mm Drill
(Note: Do not drill too deep)
Important Notes:
All screens are thoroughly inspected and fully tested operational in factory.
We accept no liability whatsoever for any losses due to improper wiring, installation, operation, or any unauthorized alternation at the point of installation.
All trademarks contained in this installation guide are the property of their respective owners.
CCOPYRIGHTS 1998 REMACO TECHNOLOGIES PTE LTD Website: www.remacotech.com
Hook on (NOT slide in)
Operation
Pull
Pull down the screen
with lanyard or hook.
1 2
1
2
To Use:
1212
To Keep:
Use hand to set at desired
position.
Pull down screen slightly
to release.
Screen move up slowly and
smoothly like a motorized
screen.
Mounting

End
Recommended Operation of Semi-Auto Screen (SAS)
It is recommended to keep the screen (roll it up) if not in use.
Common issue when SAS Screen is left in down position overnight
If SAS Screen is left in down position overnight,
you may face some issue retracting ( rolling it up )
the screen the next day. The Kinetic energy in the
screen need to be “re-charge” by leaving the screen
in the kept position.
If it cannot retract by itself, please use your hand
to gently push the screen up.
** Remarks: After leaving it in the kept position for
about 5mins, Kinetic energy will be restored and screen
will be back to its original capability.
SAS Spring Strength Adjustment
Hey Look. This is
where the white
adjustment knob
is located.
White
Adjustment
Knob
Decrease Strength
Increase Strength
Fabric
Adjustment of Spring Strength
If SAS Screen is not able roll up fully (Kept Position), it is due spring power energy not enough.
Turn white knob as shown to “increase strength” of spring. Likewise if screen roll up too fast,
adjust white knob to “decrease strength”.