Repotec Powerline 85M User manual

User’s Manual
Powerline
85M Router

Index
FCC Part 68..............................................................................................................................................................3
FCC Part 15..............................................................................................................................................................4
Chapter 1 Introduction..............................................................................................................................................5
1.1 Overview ...........................................................................................................................................5
1.2 Features............................................................................................................................................5
1.3 System Requirements.......................................................................................................................6
Chapter 2 Installation................................................................................................................................................7
2.1 Checklist............................................................................................................................................7
2.2 The Front LEDs.................................................................................................................................8
2.3 The Rear Ports..................................................................................................................................8
2.4 The Bottom Port................................................................................................................................9
Chapter 3 Configuration............................................................................................................................................9
3.1 Determine your connection settings..................................................................................................9
3.2 Connecting the Powerline Router to your network............................................................................9
3.3 Configuring with Web Browser....................................................................................................... 10
3.3.1 DHCP Server............................................................................................................................... 12
3.3.2 DHCP Client................................................................................................................................ 13
3.3.3 UPnP Configuration..................................................................................................................... 14
3.4.1 Dynamic IP.................................................................................................................................. 15
3.4.2 Static IP....................................................................................................................................... 16
3.4.3 PPPoE......................................................................................................................................... 17
3.4.4 Unnumbered PPPoE Setting....................................................................................................... 18
3.4.5 PPTP Setting............................................................................................................................... 19
3.4.6 L2TP Setting................................................................................................................................ 20
3.5.1 Access Control List...................................................................................................................... 22
3.5.2 Domain Blocking ......................................................................................................................... 23
3.5.3 URL Filter Configuration.............................................................................................................. 24
3.6.1 Virtual Server............................................................................................................................... 25
3.6.2 Rate Policing Qos........................................................................................................................ 26
3.6.3 Port-Trigger ................................................................................................................................. 27
3.6.4 DMZ Host.................................................................................................................................... 28
3.7.1 Dynamic DNS.............................................................................................................................. 29
3.7.2 MAC Clone.................................................................................................................................. 30
3.7.3 Remote Management.................................................................................................................. 31
3.7.4 User Management....................................................................................................................... 32
3.7.5 Time Zone Management............................................................................................................. 33
1

3.7.6 Firmware Upgrade....................................................................................................................... 34
3.7.7 Factory Reset.............................................................................................................................. 35
3.8.1 System Log ................................................................................................................................. 36
3.9.1 TCP/IP Settings for Windows Operating System........................................................................ 37
Chapter 4. Powerline Networking Utility................................................................................................................ 44
4.1 Configuration Utility Setup.............................................................................................................. 44
4.1.1 Installation of the Utility............................................................................................................... 44
4.2 Windows Configuration Utility ........................................................................................................ 45
4.3 User Interface................................................................................................................................. 46
4.3.1 Main Screen................................................................................................................................ 46
4.3.2 Privacy Screen............................................................................................................................ 50
4.4 Diagnostics Screen ........................................................................................................................ 51
4.4.1 About Screen............................................................................................................................... 53
4.4.2 Preferences................................................................................................................................. 53
4.5 Troubleshooting.............................................................................................................................. 54
4.5.1 When the remote Powerline devices can not connect or access? ............................................. 54
Appendix A Glossary.............................................................................................................................................. 56
Appendix B Cabling / Connection.......................................................................................................................... 63
2

FCC Part 68
This equipment complies with Part 68 of the FCC Rules. On the bottom of this equipment is a label that contains
the FCC Registration Number and Ringer Equivalence Number (REN) for this equipment. You must provide this
information to the telephone company upon request.
The REN is useful to determine the quantity of devices you may connect to the telephone line and still have those
entire devices ring when your number is called. In most, but not all areas, the sum of the REN of all devices
connected to one line should not exceed five (5.0). To be certain of the number of devices you may connect to
your line, as determined by the REN, you should contact your local telephone company to determine the
maximum REN for your calling area.
If the modem causes harm to the telephone network, the telephone company may discontinue your service
temporarily.
If possible, they will notify you in advance. But if advance notice isn't practical, you will be notified as soon as
possible.
You will be advised of your right to file a complaint with the FCC.
The telephone company may make changes in its facilities, equipment, operations, or procedures that could
affect the proper operation of your equipment. If they do, you will be notified in advance to give you an opportunity
to maintain uninterrupted telephone service.
If you experience trouble with this modem, please contact your dealer for repair/warranty information. The
telephone company may ask you to disconnect this equipment from the network until the problem has been
corrected or you are sure that the equipment is not malfunctioning.
This equipment may not be used on coin service provided by the telephone company. Connection to party lines is
subject to state tariffs.
3

FCC Part 15
The modem generates and uses radio frequency energy. If it is not installed and used properly in strict
accordance with the user's manual, it may cause interference with radio and television reception. The modem has
been tested and found to comply with the limits for Class B computing devices in accordance with the
specifications in Subpart B, Part 15 of the FCC regulations. These specifications are designed to provide
reasonable protection against such interference in a residential installation. However, there is no guarantee that
interference will not occur in a particular installation. FCC regulations require that shielded interface cables be
used with your modem.
If interference does occur, we suggest the following measures be taken to rectify the problem:
1) Move the receiving antenna.
2) Move the modem away from the radio or TV.
3) Plug the modem into a different electrical outlet.
4) Discuss the problem with a qualified radio / TV technician.
CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance to the FCC Rules could
void the user's authority to operate this equipment.
Cable connections:
All equipment connected to this modem must use shielded cable as the interconnection means.
Notes:
Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) This device must accept any interference received including interference that may cause undesired
operation.
4

Chapter 1 Introduction
Congratulations on your purchase of an Instant Powerline Router with 4-port Fast Ethernet Switch and Homeplug
for cable and DSL application. The Powerline Router is the perfect option to connect a small group of PCs to a
high-speed Broadband Internet connection or to an Ethernet backbone. Configurable as a DHCP server, the
Broadband Router acts as the only externally recognized Internet device on your local area network (LAN). The
Router serves as an Internet firewall, protecting your network from being accessed by outside users.
1.1 Overview
Unlike a simple hub or switch, the setup of the Cable/DSL Router consists of more than simply plugging
everything together. Because the Router acts as a DHCP server, you will have to set some values within the
Router, and also configure your networked PCs to accept the IPAddresses the Router chooses to assign them.
And generally there are three different operating modes for your applications.And you can know which mode is
necessary for your system from ISP. These three modes are PPPoE, DHCP client and Static IP.Actually all these
are for IP address of WAN.
1.2 Features
zRouter Mode
‧PPP over Ethernet (RFC-2516)
‧DHCP Server and Client
‧NAPT (Network Address and Port Translation)
‧NAT (Network Address Translation
zInternet Access
‧TCP/IP, UDP, ICMP, ARP, RARP, PPPoE, NAT, DHCP (client/server), Static IP assignment
zSecurity Features
‧Password protected configuration access
‧User authentication (PAP/CHAP) for PPP connection
zSecurity
‧Provide 56-bit DES link encryption for Powerline network
‧Stateful packet inspection and filtering
‧Intrusion detection and protection
‧Password protected system management
zEthernet Interface
‧Compliant with IEEE 802.3 and 802.3u 10/100 Mbps
zHTTP Web-Based Management
‧Firmware upgrade by UI
‧WAN and LAN side connection statistics
5

‧Password protected access
‧System log
1.3 System Requirements
1) Personal computer (PC)
2) Pentium II 233 MHz processor minimum
3) 32 MB RAM minimum
4) 20 MB of free disk space minimum
5) Ethernet Network Interface Controller (NIC) RJ45 Port
6) Internet Browser
6

Chapter 2 Installation
This chapter offers information about installing your router. If you are not familiar with the hardware or software
parameters presented here, please consult your service provider for the values needed.
2.1 Checklist
Check the shipping box carefully to ensure that the contents include the items you ordered. If any of the items are
missing or damaged, contact your local distributor. The contents of your carton may vary depending on your
service provider.
Contents description
1) Powerline Router for home/office use
2) Powerline Router Installation and Operation Guide (this publication)
3) Power Cord
4) Ethernet cable Ethernet category 5 twisted pair cable (6 ft)
Application for this device
7

2.2 The Front LEDs
LED State Description
POWER ON Press the button to power one the router.
OP Flashing The router running well.
PL Flashing When the router detect other Powerline devices
ON Link
Flashing TX or RX activity
LAN
1-4 OFF
No Link
These four LAN (Local Area Network) ports are where you will connect networked
devices, such as PCs, print servers remote hard drives, and anything else you want to
put on your network.
ON "Showtime"-successful connection betweenADSL modem and telephone company's
network.
Flashing "Handshaking"-modem is trying to establish a connection to telco's network Modem is
powered OFF ADSL Carrier Detect if LED is flash.
WAN
OFF No link.
2.3 The Rear Ports
Connector Description
POWER Connect to power cord.
LAN (1-4) Router is successfully connected to a device through the corresponding port (1, 2, 3 or 4).
If the LED is flashing, the Router is actively sending or receiving data over that port.
WAN The WAN (Wide Area Network) Port is where you will connect your cable, DSL modem or
Ethernet backbone.
8

2.4 The Bottom Port
Connector Description
Reset Switch The reset button, the router restore default settings when press until reboot.
Chapter 3 Configuration
3.1 Determine your connection settings
Before you configure the router; you need to know the connection information supplied by your service provider.
3.2 Connecting the Powerline Router to your network
Unlike a simple hub or switch, the setup of the ADSL Router consists of more than simply plugging everything
together.
Because the Router acts as a DHCP server, you will have to set some values within the Router, and also
configure your networked PCs to accept the IPAddresses the Router chooses to assign them. Generally there
are several different operating modes for your applications. And you can know which mode is necessary for your
system from ISP. These modes are router, bridge, PPPoE+NAT and NAT.
9

3.3 Configuring with Web Browser
It is advisable to change the administrator password to safeguard the security of your network.
To configure the router, open your browser, type 'http://192.168.6.1' into the address bar and click 'Go' to get to
the login page. Save this address in your Favorites for future reference.
At the Password prompt, the User name is 'admin' and the password is ’admin’. You can change these later if
you wish. Click 'OK' to login.
10

You can use "Quick Setup" to setup the router, and choose the connect mode you prefer.
11

3.3.1 DHCP Server
The "DHCP Server" option enables you to configure the LAN port.
If you enable the DHCP server status, the router will auto assign the IP address to the DHCP clients. You can
decide the IP Pool form 1 to 253.
12

3.3.2 DHCP Client
The DHCP client list allows you to see which clients are connected to the router via IP address and MAC address.
13

3.3.3 UPnP Configuration
UPnP (Universal Plug-and-Play). Network architecture based on TCP/IP and intended to allow terminals to be
networked without the need for configuration. In the Barricade router, for example, the correct ports are
automatically opened for applications like Netmeeting, online games, etc. You can choose to enable or disable
the UPnP Service.
14

3.4.1 Dynamic IP
If you set the WAN as a Dynamic IP, the router will get the WAN IP address automatically.
15

3.4.2 Static IP
You can set the router’s WAN IP as static IP address. You need to fill out the Subnet Mask, Default Gateway and
DSN too.
16

3.4.3 PPPoE
PPPoE is usually used by ISPs which provide ADSL line to their subscribers. Usually an ISP gives Login ID and
Password to users for login when connecting to Internet. Service Name, AC Name is usually optional.
MTU: Sometimes ISP sets different MTU size than 1492. This value would be set to hardware. Dial-on-demand:
If checked, router won’t dial this session until received a LANWAN packet. If unchecked, router dials this session
immediately after system powered up. Silent timeout: If specified a non-zero value, router disconnects this
session after specified idle time. Auto Reconnect: If checked, router redials this session if session previously
terminated by ISP. Dial Status: Current status of this session. May be “Connected”, “Connecting”, or “Disconnect”
Pressing the Save and Restart saves parameters and reboots the router.
17

3.4.4 Unnumbered PPPoE Setting
Unnumbered PPPoE WAN type is a required feature in Japan. ISP assigns Login ID and Password to users for
login when connecting to Internet. Service Name,AC Name is usually optional. It’s required to set the following
parameters for Unnumbered PPPoE WAN type: IP address: The unnumbered IP subnet address, assigned by
ISP. Network Mask : Network size of the unnumbered IP subnet. NAPT for LAN hosts: If checked, the router
enables hardware NAPT function for LAN PCs using configured LAN IP address(ex:192.168.1.X). If unchecked,
NAPT is disabled and only routes packets to and from LAN PCs using unnumbered IP addresses.All other
options are same as those of PPPoE Setting in Section 3.4.1. Pressing the Save and Restart saves parameters
and reboots the router.
18

3.4.5 PPTP Setting
IP address：The IP address gateway uses to communicate with remote PPTP server.
Subnet Mask：Network mask of gateway’s IP address
PPTP Server IP Address：Remote PPTP server’s IP address . All other options are same as those of PPPoE
Setting.
19