Resolution RE352 User manual

RE352_DSC-Compat_PIN-Pad Page 1 of 3 30-Oct-14
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
RE352 DSC-Compatible PINpad™
Features
• Secure, 4-digit Code to disarm
• 1-button arming
• Red/Green LED arming eedback
• Small, yet com ortable keypad
• Mounts on wall via VHB® tape, or screws
• Secure or carrying in purse or mounting on car visor
• Strong, reliable RF signal.
• 4-6 year battery li e on CR2032 battery.
Key Instructions
• Enroll as a Key Fob.
• Code programming
De ault access code is “1234”.
To change access code:
1. Enter current 4-digit access code.
2. Within 4 seconds, press and hold the “1” and “3” keys
simultaneously. A ter 3 seconds, Red LED will be lit.
3. Enter new 4-digit access code. A ter success ully changing
the code, the Green LED will be lit
4. Note new access code . BAD GUY CANNOT RESET CODE.
So it must be noted and remembered!
• Enrolling:
1. Re er to the DSC control unit installation manual.
2. I panel is capable o Wireless Enrollment Mode, put the
control panel in that mode and both the STAY or AWAY
buttons or 3 seconds.
Or, put panel in Serial Number Entry Mode and program in
the printed ESN.
3. Set up as you would a WS4939 4-Button Fob.
Operation
PINpad
Button Panel Action LED
Stay
ARM STAY
lashes double red
Away
ARM AWAY
lashes double red twice
PIN Code
DISARM
lashes double green
Stay + Away
PANIC ALARM
lashes red 8 tim
es
RE352_DSC-Compat_PIN-Pad Page 2 of 3 30-Oct-14
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
Pictures
Battery Replacement
CR2032 Battery
+ Terminal up
Insert Screwdriver
here
to open
Red/Green
Status LED
Shows command sent
Stay + Away
=
Panic (Enroll)
TO CHANGE PIN CODE:
Current 4-digit access code, and then…
1 + 3  Red LED,and then…
Enter New Code

RE352_DSC-Compat_PIN-Pad Page 3 of 3 30-Oct-14
24-Hour Tech Support Line: [phone]
www.ResolutionProducts.com
Specifications
Secure replacement to a DSC WS4939 4-Button Key Fob.
Not supervised.
Replacement Battery: CR2032 Lithium / Manganese Dioxide
Temperature Range: 0F to 120F
Housing dimensions: 2x2.25x0.33 inches
1-way RF: Does not receive panel status
Speci ications subject to change without notice.
Notices
“GE” “Honeywell” “DSC” “2GIG” and “Napco” are trademarks owned by General Electric
Company Honeywell International Inc. Tyco Safety Products Canada LTD 2GIG Technologies
Inc. and NAPCO Security Systems Inc. respectively.
Resolution Products Inc. products will function with one of either GE Honeywell DSC or
Napco systems. However no Resolution product is produced by endorsed by nor is officially
associated with GE Honeywell DSC or Napco. Resolution recommends verifying proper
enrollment and operation per control panel installation instructions at installation.
Warranty
Resolution Products Inc. will replace products that are defective in their first five (5) years.
FCC Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
This device may not cause harmful interference.
This device must accept any interference that may be received including
interference that may cause undesired operation.
Changes or modifications not expressly approved by the Resolution Products Inc. could
void the user's authority to operate this equipment.
FCC ID: U5X-RE352
IC Notice
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1)This device may not cause interference and
(2)This device must accept any interference including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1)l'appareil ne doit pas produire de brouillage et
(2)l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi
même si le brouillage est susceptible d'en compromettre le fonctionnement.
IC: 8310A-RE352