Rev-A-Shelf SIDEMOUNT PULLOUT 150 MM User manual

TOOLS REQUIRED:
30 MIN
ESTIMATED ASSEMBLY TIME:
CARE AND MAINTENANCE:
• Clean with a damp cloth and
wipe parts dry
• Lubricate pivot points as
needed
SIDEMOUNT PULLOUT 150 MM
A.
B.
C.
Parts List
No. Description Qty
A Slide 1 Set
B Basket 1
C Door Mounting Bracket 1 Set
D M5 x 20 mm Machine Screws 2
E 4G x 18 mm Pan Head Screws 8
F 4G x 18 mm Flat Head Screws 6
G M5 x 15 mm Flat Head Screws 4
INSTALLATION INSTRUCTIONS: SIDEMOUNT PULLOUT I-5776-150-0518
D.
#2
3
mm
E. F. G.

2
Using the dimensions in Figure B,
install the slides to the side of
the cabinet using (6) of the
4G x 18 mm pan head wood
screws.
Slide the unit onto the slides by
placing the back of the unit on the
back of the slides. This engages the
hook mechanism, then press the
slides down. You will hear a click, and
the slides are engaged
(See Figure C).
C-2 is a close up image of pressing
down so the slides are fully engaged.
C-3 is a close up image of sliding the
unit onto the back of the slide.
#2
3
mm
STEP 1
FIGURE A
110 mm
206 mm
302 mm
465 mm
65 mm
STEP 2
#2
CHOOSING THE DESIRED
BOTTOM SHELF
The shelf on the basket is reversable.
You can have a white or gray bottom.
To change the color remove the
retaining clips. Flip the board over
and put clips back into place
(See Figure A).
FIGURE B
E
FIGURE C
C-2
C-3

3
Using the dimensions in Figure D,
mount the door mounting brackets
to the door using (6) 4G x 18 mm at
head wood screws.
FIGURE D
561.5 mm
60 mm
161.5 mm
STEP 3
#2
3
mm
FIGURE E
FIGURE F
Secure the unit to the door
mounting brackets by using the (4)
M5 x 15 mm at head screws
(See Figure E).
Screw in the (2) M5 x 20 mm pan
head screws into the center hole
on the door mounting brackets to
further secure the brackets to the
unit (See Figure F).
STEP 4
STEP 5
#2
#2
F
G
D

4
If the cabinet door is not lining up
correctly, use the images in Figures
D-1 through D-3 to loosen and
tighten the door mounting screws to
properly adjust the cabinet door.
DOOR ADJUSTMENT
#2
FIGURE D-1
FIGURE D-2
FIGURE D-3