RH LEVI TASK Programming manual

LEVI TASK WALL LAMP COLLECTION
ASSEMBLY & INSTALLATION INSTRUCTIONS
UNITED STATES ENGLISH

LEVI TASK WALL LAMP COLLECTION UNITED STATES ENGLISH
RH.COM
REVISION 06-10-22
LEVI TASK WALL LAMP
PARTS INCLUDED
(A) Wall Bracket (1)
(B) Wall Bracket Screws (2)
(C) Lamp Body (1)
(D) Stem (1)
(E) G9 LED Bulb (3)
(F) Diffuser (1)
(G) Disc Finial (1)
(H) Rotary Dimmer Switch (1)
TOOLS NEEDED
(IF APPLICABLE)
(I) Phillips Head Screwdriver
(not included)
(A)
(C)
(D)
(F)
(G)
(B)
(E)
(H)

LEVI TASK WALL LAMP COLLECTION UNITED STATES ENGLISH
RH.COM
REVISION 06-10-22
IMPORTANT: PLEASE READ
PLEASE FOLLOW THE ASSEMBLY INSTRUCTIONS CLOSELY.
IMPROPER ASSEMBLY OR INSTALLATION CAN RESULT IN
PERSONAL OR PROPERTY DAMAGE. MOUNTING HARDWARE
HAS BEEN PROVIDED FOR YOUR CONVENIENCE AND SHOULD
BE USED WITH DISCRETION. ALWAYS USE THE APPROPRIATE
HARDWARE FOR THE MOUNTING SURFACE.
IMPORTANT SAFETY FEATURES
BULBS
This fixture has been rated for up to three (3) 6-watt maximum LED
lightbulbs. To avoid the risk of fire, do not exceed the recommended
wattage.
DIMMER-SWITCH COMPATIBILITY
This fixture is not dimmer-switch compatible.
WARNINGS
All wires are connected. When unpacking, be careful not to pull wires,
as damage may result. Do not connect electricity until the fixture is
fully assembled. To reduce the risk of fire, electrical shock, or personal
injury, always turn off fixture and allow it to cool prior to replacing
the lightbulb. Do not touch or look directly at the bulb when fixture is
illuminated. Keep flammable materials away from lit bulb.
WARNING STRANGULATION HAZARD
Keep cord at least 3 feet away from cribs, bassinets, and toddler beds.
Keep out of reach of children under 3 years of age.
THIS PRODUCT IS NOT A TOY AND HAS NO PLAY VALUE.
ASSEMBLY AND INSTALLATION
1. Attach wall bracket (A) to wall with wall bracket screws (B)
2. Insert the power cord through the slot in the side of the wall bracket (A).
3. Feed the cord through the wall bracket (A) until the stem (D) is
securely seated in the wall bracket (A).
4. Insert the three G9 LED bulbs (E) into the sockets in the lamp body (C).
5. Align the diffuser (F) with the bottom of the lamp body (C) and attach
by screwing in the disc finial (G).
6. This fixture allows rotation at the wall bracket (A) and where the
stem (D) enters the lamp body (C). NOTE: This fixture does not allow
height adjustment.
7. Insert plug into wall outlet to power the fixture. Rotary dimmer
switch (H) is located on the top surface of the lamp body (C). For best
dimming performance, turn the switch up to full brightness before
dimming down to the desired level.
CARE INSTRUCTIONS
Do not use polishes or cleaners on the fixture. Wipe clean with a soft,
dry cloth.