RONAN TASK FLOOR LAMP
IMPORTANT SAFETY INSTRUCTIONS
INSTALLATION BY A LICENSED ELECTRICIAN IS STRONGLY
RECOMMENDED.
1. Do not break or pull out LED lightbulb.
2. Indoor use only.
3. Do not look directly at the light.
4. Keep lamp away from materials that may burn.
5. If the supply cord or adapter is damaged, it must be replaced
only by a service agent or a qualified technician.
WARNINGS
All wires are connected. When unpacking, be careful not to pull
wires, as a bad connection may result. Do not connect electricity
until your fixture is fully assembled. To reduce the risk of fire,
electrical shock, or personal injury, always turn off fixture and allow it
to cool prior to replacing the lightbulb. Do not touch or look directly
at the bulb when fixture is illuminated. Keep flammable materials
away from lit bulb.
THIS PRODUCT IS NOT A TOY AND HAS NO
PLAY VALUE.
WARNING: STRANGULATION HAZARD
Keep cord at least 3 feet away from cribs, bassinets, and toddler
beds. Keep out of reach of children under 3 years of age.
ASSEMBLY & INSTALLATION
1. Carefully remove all parts from the box and remove all plastic
coverings.
2. Remove Protective Cover (C) from the plug.
3. Plug into proper electrical outlet and test fixture.
4. Assembly is complete.
TO ADJUST HEIGHT:
1. Loosen Break (B) by turning in a counter-clockwise direction.
2. Adjust lamp by pulling or pushing Pole (A) up or down to the
desired height.
3. Tighten Break (B) by turning in a clockwise direction.
TO OPERATE SWITCH:
1. To turn lamp on, simply tap the switch.
2. To adjust brightness, tap and hold your finger on the switch. The
light will begin to brighten or dim. To change the direction of
brightening or dimming, remove your finger, then tap and hold
again until the desired light level is achieved.
3. To turn lamp off, tap the switch.
Caution: Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment.
IC COMPLIANCE
This Class B digital apparatus complies with CAN ICES-005 (B)/
NMB-005(B). NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio
frequency energy, and if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to connect the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and plug into
an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for
help.
CARE INSTRUCTIONS
Do not use polishes or cleaners on the lamp. Wipe clean with a soft,
dry cloth.
ASSEMBLY & INSTALLATION CONT.
