RH FORTUNY STUDIO 76 User manual

FORTUNY® STUDIO 76 TRIPOD FLOOR LAMP
Page 1 of 4
PLEASE FOLLOW THE ASSEMBLY INSTRUCTIONS
CLOSELY. IMPROPER ASSEMBLY OR INSTALLATION
CAN RESULT IN PERSONAL OR PROPERTY DAMAGE.
IF YOU ARE UNSURE ABOUT WHAT MOUNTING
METHOD YOU SHOULD USE, CONSULT A QUALIFIED
PROFESSIONAL OR YOUR LOCAL HARDWARE STORE.
PARTS ENCLOSED:
(A) Head
(B) Rod
(C) Hex nut
(D) Friction lock
(E) Stand
(F) Pin
(G) Wing nut
(H) Wheels
(I) Light bulb
(J) Bulb cover
(K) Knurled screw
(L ) Cone
(M) Electrical cable
SIDE FRONT
(A)
(L)
(F)
(G)
(M)
(G)
(B)
(C)
(J)
(J)
(K)
(K)
(I)
(D)
(E)
(H)

FORTUNY STUDIO 76
Page 2 of 4
1. Unscrew hex nut (C) from head (A).
2. Insert rod (B) into hex nut (C)
(as you can see in the figure).
3. Open the tripod stand (E)
and unscrew the friction lock (D).
Insert rod (B) into (D)
(as you can see in the figure).
4. Now you can insert pin (F) of the head
onto the top of the rod (B).
Then lift and screw tight hex nut (C)
(by hand only).
ASSEMBLY & INSTALLATION:
A1
A2
A3 A4

FORTUNY STUDIO 76
Page 3 of 4
IMPORTANT PLEASE READ
To tilt head, loosen the wing nuts (G),
select the prefered position of the head,
then tight the wing nuts (G).
To extend rod (B) unscrew friction lock (D), lift head
to the prefered position, then screw friction lock (D).
To remove, loosen or tighten the wheels (H),
use a n.8 open-end wrench.
The head must not be inserted during these procedures.

FORTUNY STUDIO 76
Page 4 of 4
IMPORTANT PLEASE READ
To replace the bulb, unscrew (K) by hand
and pull gently bulb cover (J).
Screw the light bulb (max 15W LED E26 dimmable).
STUDIO 76 come with crossbar and black bulb cover
as shown in the drawing.
CARE INSTRUCTIONS:
Wipe all surfaces with a soft, dry cloth.
Do not use any harsh cleaners (including ammonia-based products) or abrasives, as they will damage the finish.
The Cone should be cleaned periodically with a soft cloth dampened with water.
The inner part of the lamp should be cleaned periodically only with a soft cloth.

FORTUNY STUDIO 76
TECHNICAL PRODUCT SHEET:
A. diffuser diameter ......................................... 29 1/4 in. (cm 75)
B. standard height ........................................... 85 3/4 in. (cm 220)
minimum ...................................................... 82 in. (cm 210)
maximum ..................................................... 92 in. (cm 236)
C. tripod height ............................................... 40 1/2 in. (cm 104)
D. wheels height ............................................. 2 3/8 in. (cm 6)
E. diffuser depth ............................................. 14 1/2 in. (cm 37,5)
F. tripod width .................................................. 30 1/2 in. (cm 78)
G. tripod depth ................................................. 27 in. (cm 69)
weight ................................................................ lb.33 oz.1 (15 kg)
voltage: 110/120V
wattage: max 15W LED dimmable
socket: E26
E
F
G
B
A
C
D