RH PAUILLAC User manual

PAUILLAC FABRIC SHADE TORCHE SCONCE
PARTS ENCLOSED
(A) Mounting Plate (1)
(B) Mounting Screws (2)
(C) Set Screws (2)
(D) Fixture Base (1)
(E) Allen Wrench (1)
(F) Shade Bracket (1)
(G) Bulb (1)
(H) Shade (1)
(I) Rod (1)

PAUILLAC FABRIC SHADE TORCHE SCONCE
IMPORTANT SAFETY INSTRUCTIONS
INSTALLATION BY A LICENSED ELECTRICIAN IS STRONGLY
RECOMMENDED.
This fixture has been rated for one (1) 25-Watt max Type T lightbulb
(included). To avoid the risk of fire, do not exceed the recommended
wattage.
WARNINGS
All wires are connected. When unpacking, be careful not to pull
wires, as a bad connection may result. Do not connect electricity
until your fixture is fully assembled. To reduce the risk of fire,
electrical shock, or personal injury, always turn off fixture and allow it
to cool prior to replacing the light bulb. Do not touch or look directly
at the bulb when fixture is illuminated. Keep flammable materials
away from lit bulb.
WARNING: This product can expose you to lead, which is
known to the State of California to cause cancer and birth defects or
other reproductive harm. For more information, go to
www.P65Warnings.ca.gov.
THIS PRODUCT IS NOT A TOY AND HAS NO
PLAY VALUE.
WARNING: STRANGULATION HAZARD
Keep cord at least 3 feet away from cribs, bassinets, and toddler
beds. Keep out of reach of children under 3 years of age.
ASSEMBLY & INSTALLATION
SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE FUSE
BOX OR CIRCUIT BREAKER PANEL.
1. Carefully remove all parts from the box and remove all plastic
coverings.
2. Remove Mounting Plate (A) from Fixture Base (D) by
unscrewing Set Screws (C) using Allen Wrench (E).
3. Affix Mounting Plate (A) to the wall outlet box by aligning the
holes and secure with Mounting Screws (B).
4. Gently pull the wire from wall outlet box and allow the wire
to hang. Thread the wire through the center hole in Mounting
Plate (A).
5. Affix the fixture ground wire (green) to the ground wire (usually
bare copper) from the wall outlet box with a wire nut. IT IS
IMPERATIVE THAT THE OUTLET BOX IN YOUR HOME BE
PROPERLY GROUNDED.
6. Connect the neutral wire (white) to the neutral outlet wire
(usually white) with a plastic wire connector and wrap the
connection with electrical tape.
7. Connect the hot wire (black) to the hot outlet box wire
(usually black) with a plastic wire connector and wrap the
connection with electrical tape. DO NOT REVERSE THE
HOT AND NEUTRAL CONNECTIONS OR SAFETY WILL BE
COMPROMISED.
8. Carefully tuck the wires back into the outlet box.
9. Attach Fixture Base (D) to the affixed Mounting Plate (A).
Secure with Set Screws (C), then tighten with Allen Wrench (E).
10. Insert Bulb (G) into the socket.
11. Place Shade (H) onto Shade Bracket (F).
12. Screw Rod (I) onto the bottom nipple of the fixture by turning in
a clockwise direction until tight.
13. Restore power to outlet box and check operation of fixture.
14. Assembly is complete.
CARE INSTRUCTIONS
Do not use polishes or cleaners on the fixture. Wipe clean with a
soft, dry cloth.