RH ROWAN PHARMACY TASK TABLE LAMP User manual

ROWAN PHARMACY TASK TABLE LAMP
(A)
(A)
(B)
(E)
(F)
(C)
(G)
(H) (J)
(K)
(B) (D)
(L)
PARTS ENCLOSED
(A) Shade (1)
(B) Adjustment Key (1)
(C) Adjustment Key (1)
(D) Swivel Joint (1)
(E) Balance Arm (1)
(F) Upper Pole (1)
(G) Lower Pole (1)
(H) Tripod Base (1)
(I) Electrical Plug (1)
(K) Protective Cover (1)
(L) LED Bulb (1)

ROWAN PHARMACY TASK TABLE LAMP
IMPORTANT SAFETY INSTRUCTIONS
For safety purposes, this lamp is equipped with a polarized plug (one
blade is wider than the other). If the plug does not fit securely into
outlet, do not force it - contact a professional electrician. Use the
plug with an extension cord only if it can be fully inserted into the
cord’s socket. Never alter the plug in any way.
This fixture has been rated for one (1) 60-Watt maximum TYPE A
standard bulb (not included) OR 20-Watt Compact Fluorescent bulb
(not included) or one 4.5-Watt SBLED light bulb (L) (included). To
avoid the risk of fire, do not exceed the recommended wattage.
WARNINGS
All wires are connected. When unpacking, be careful not to pull
wires, as a bad connection may result. Do not connect electricity
until your fixture is fully assembled. To reduce the risk of fire,
electrical shock, or personal injury, always turn off fixture and allow it
to cool prior to replacing the light bulb. Do not touch or look directly
at the bulb when fixture is illuminated. Keep flammable materials
away from lit bulb.
WARNING: This product can expose you to lead, which is
known to the State of California to cause cancer and birth defects or
other reproductive harm. For more information, go to
www.P65Warnings.ca.gov.
THIS IS NOT A TOY AND THE PRODUCT HAS NO
PLAY VALUE.
WARNING: STRANGULATION HAZARD
Keep cord at least 3 ft away from cribs, bassinets, and toddler beds.
Keep out of reach of children under 3.
ASSEMBLY & INSTALLATION
1. Carefully remove all parts from the box and remove all plastic
covering.
2. Remove white plastic bushing inside hole on top of Tripod Base
(H) before assembling.
3. Thread Pole (G) into top opening of Tripod Base (H).
4. Thread Balance Arm (E) into side opening of Swivel Joint (D).
5. Insert the recommended Bulb (not included) into threaded
socket.
6. Plug into proper electrical outlet and test fixture.
7. Assembly is complete.
HEIGHT ADJUSTMENT
1. Loosen Adjustment Keys (B), (C) in the counter-clockwise
direction.
2. Adjust lamp by pulling or pushing Upper Pole (F) up or down to
desired height, and/or swing lamp arm or Shade (A) to desired
position.
3. Tighten the Adjustment Keys (B), (C) in the clockwise direction.
CARE INSTRUCTIONS
Do not use polishes or cleaners on your lamp. Just wipe clean with
a soft cloth.