RH NORRIS TASK FLOOR LAMP User manual

NORRIS TASK FLOOR LAMP
PARTS ENCLOSED
(A) Shade (1)
(B) Bulb (1)
(C) Inner Rod (1)
(D) Break (1)
(E) Pole (1)
(F) Lamp Base (1)
(G) Washer (1)
(H) Nut (1)
(I) Wrench (1)
(J) Felt Pad (1)

NORRIS TASK FLOOR LAMP
IMPORTANT SAFETY INSTRUCTIONS
INSTALLATION BY A LICENSED ELECTRICIAN IS STRONGLY
RECOMMENDED.
This xture has been rated for one (1) 60-watt Type T lightbulb
(not included), one (1) 13-watt compact uorescent lightbulb (not
included), or one (1) 5.5-watt SBLED lightbulb (included). To avoid
the risk of re, do not exceed the recommended wattage.
WARNINGS
All wires are connected. When unpacking, be careful not to pull
wires, as a bad connection may result. Do not connect electricity
until your fixture is fully assembled. To reduce the risk of fire,
electrical shock, or personal injury, always turn off fixture and allow it
to cool prior to replacing the lightbulb. Do not touch or look directly
at the bulb when fixture is illuminated. Keep flammable materials
away from lit bulb.
WARNING: This product can expose you to lead, which is
known to the State of California to cause cancer and birth defects or
other reproductive harm. For more information, go to
www.P65Warnings.ca.gov.
THIS PRODUCT IS NOT A TOY AND HAS NO
PLAY VALUE.
WARNING: STRANGULATION HAZARD
Keep cord at least 3 feet away from cribs, bassinets, and toddler
beds. Keep out of reach of children under 3 years of age.
ASSEMBLY & INSTALLATION
SHUT OFF THE MAIN ELECTRICAL SUPPLY FROM THE FUSE
BOX OR CIRCUIT BREAKER PANEL.
1. Carefully remove all parts from the box and remove all plastic
coverings.
2. Connect Pole (E) to Base (F) and secure with Washer (G) and
Nut (H) using Wrench (I).
3. Remove adhesive backing from Felt Pad (J) and carefully apply
to the bottom of Base (F).
4. Insert Bulb (B) into the threaded socket.
5. Adjust Shade (A) to the desired position if needed.
6. Loosen Break (D) to adjust Rod (C) to the desired height if
needed, then tighten Break (D).
7. Plug into proper electrical outlet and test xture.
8. Assembly is complete.
CARE INSTRUCTIONS
Do not use polishes or cleaners on the fixture. Wipe clean with a
soft, dry cloth.