RH 1940S User manual

1940S ARCHITECT’S BOOM FLOOR LAMP
PARTS ENCLOSED
(A) Lamp Base (1)
(B) Lamp Pole (1)
(C) Adjustment Key (1)
(D) Inner Pole (1)
(E) Lamp Arm (1)
(F) Shade Holder (1)
(G) Thumbscrews (4)
(H) Lamp Shade (1)
(J) Washer (1)
(K) Socket Ring (1)
(L) LED Bulb (1)

1940S ARCHITECT’S BOOM FLOOR LAMP
IMPORTANT SAFETY INSTRUCTIONS
For safety purposes, this lamp is equipped with a polarized plug (one
blade is wider than the other). If the plug does not fit securely into
outlet, do not force it - contact a professional electrician. Use the
plug with an extension cord only if it can be fully inserted into the
cord’s socket. Never alter the plug in any way.
This fixture has been rated for one (1) 60-Watt maximum TYPE A
standard bulb (not included) OR 13W Compact Fluorescent bulb (not
included) or 4.5-Watt SBLED light bulb (L) (included). To avoid the
risk of fire, do not exceed the recommended wattage.
WARNINGS
All wires are connected. When unpacking, be careful not to pull
wires, as a bad connection may result. Do not connect electricity
until your fixture is fully assembled. To reduce the risk of fire,
electrical shock, or personal injury, always turn off fixture and allow it
to cool prior to replacing the light bulb. Do not touch or look directly
at the bulb when fixture is illuminated. Keep flammable materials
away from lit bulb.
WARNING: This product can expose you to lead, which is
known to the State of California to cause cancer and birth defects or
other reproductive harm. For more information, go to
www.P65Warnings.ca.gov.
THIS IS NOT A TOY AND THE PRODUCT HAS NO
PLAY VALUE.
WARNING: STRANGULATION HAZARD
Keep cord at least 3 ft away from cribs, bassinets, and toddler beds.
Keep out of reach of children under 3.
ASSEMBLY & INSTALLATION
1. Carefully remove all parts from the box and remove all plastic
covering.
2. Screw Lamp Arm (E) onto top threaded nipple of Inner Pole (D).
3. Screw Lamp Pole (B) onto top threaded nipple of Lamp Base
(A).
4. Remove Socket Ring (K) and Washer (J) from threaded socket.
Attach Lamp Shade (H) to Shade Holder (F) and secure with
Thumbscrews (G). Tighten with Washer (J) and Socket Ring (K).
5. Insert Bulb (L) into threaded socket.
6. Plug into proper electrical outlet and test fixture.
7. Assembly is complete.
HEIGHT ADJUSTMENT
1. Loosen Adjustment Key (C).
2. Adjust lamp by pulling or pushing Inner Pole (D) up or down to
desired height.
3. Tighten Adjustment Key (C).
CARE INSTRUCTIONS
Do not use polishes or cleaners on your lamp. Just wipe clean with
a soft cloth.