RH FORTUNY User manual

FORTUNY® STUDIO FLOOR LAMP
Page 1 of 4
PLEASE FOLLOW THE ASSEMBLY INSTRUCTIONS
CLOSELY. IMPROPER ASSEMBLY OR INSTALLATION
CAN RESULT IN PERSONAL OR PROPERTY DAMAGE. IF
YOU ARE UNSURE ABOUT WHAT MOUNTING METHOD
YOU SHOULD USE, CONSULT A QUALIFIED
PROFESSIONAL OR YOUR LOCAL HARDWARE STORE.
PARTS ENCLOSED
(A) Head
(B) Rod
(C) Fork Screw
(D) Friction Lock
(E) Stand
(F) Pin
(G) Knob
(H) Base
(I) Lightbulb
(J) Bulb Cover
(K) Knurled Screw
(L) Cone
(M) Electrical Cable
SIDE FRONT
(A)
(L)
(F)
(G)
(M)
(G)
(B)
(C)
(J)
(J)
(K)
(K)
(I)
(D)
(E)
(H)

FORTUNY® STUDIO FLOOR LAMP
Page 2 of 4
1. Unscrew Screw (C) from Rod (B).
2. Insert Rod (B) into Pin (F) as shown.
3. Screw tight Screw (C) into Pin (F).
4. Insert Rod (B) into Friction Lock (D) on top of Stand (F).
Now you can screw tight the Friction Lock (D).
ASSEMBLY & INSTALLATION
A1 A2
A3
A4

FORTUNY® STUDIO FLOOR LAMP
Page 3 of 4
To tilt head, loosen the Knobs (G),
select the preferred position of the
head, then tighten the Knobs (G).
To extend Rod (B) unscrew Friction Lock (D), lift
head to the preferred position, then screw tight the
Friction Lock (D).

FORTUNY® STUDIO FLOOR LAMP
Page 4 of 4
To replace the bulb, first turn off the electricity, then
unscrew Knurled Screw (K) by hand and gently pull off
the Bulb Cover (J). Remove Lightbulb (E).
Suggested wattage: halogen lamp max 70W-E12 /
dimmable led lamp.
ATELIER 41 comes with crossbar and black bulb cover as
shown in the drawing.
CARE INSTRUCTIONS
Wipe all surfaces with a soft, dry cloth.
Do not use any harsh cleaners (including ammonia-based products) or abrasives, as they will damage the finish.
The Cone should be cleaned periodically with a soft cloth dampened with water.
The inner part of the lamp should be cleaned periodically only with a soft cloth.