Rhyas RH160 User manual

1

2
TECHNICAL SPECIFICATION
Model:- RH160
Input Voltage:- 230V
Input Rating:- 3KW
Frequency:- 50Hz
No-Load Voltage:- 53V ± 5V
Current Range:- 20A - 160A
Duty Cycle:- 160A 35%
95A 100%
Welding Rods:- 1.0 - 3.2mm
Size L X W X H:- 410x220x270mm
Case Insulation:- IP21
Weight:- 6kg
IMPORTANT: Before using this product
please read this manual carefully. This
product should only be used for its
intended purpose, failure to do so could
cause damage to the machine, personal
injury and could invalidate the warranty.
Protect your eyes; always use a
shield/mask when welding.
GENERAL ELECTRICAL SAFETY:
• Always check electrical machinery prior
to use.
• Inspect power cables, plugs and
sockets for any signs of wear or
damage - if in doubt consult a qualified
electrical technician.
• Products that require more than
13amps are supplied without a plug,
please consult a qualified electrician to
ensure a suitable power supply.
• Unplug the inverter from the power
supply prior to connecting any cables or
carrying out any maintenance work.
GENERAL SAFETY:
• Ensure the work area is well ventilated
to prevent the build up of welding
fumes.
• To maintain the efficient running of the
machine ensure that there is a good
flow of clean cool air and no
obstructions around the cooling fan.
• Wear gauntlets and appropriate
clothing whilst welding
• It is recommended that loose jewellery
watches etc. are removed.
• Do not weld near flammable
materials; solids, liquids or gases.
• Allow welded material and the welding
torch to cool before touching.
ASSEMBLY & OPERATION:
• DO NOT plug your inverter in to the
mains until the Torch & Clamp cables
have been connected. Torch is
connected to positive (+) and clamp to
negative (-).
• IMPORTANT: the torch and clamp
cables must be fully locked into the
quick release sockets; failure to do so
can cause overheating and damage to
the machine.

3
On/Off Switch
Positive (+) Torch Connection
Negative (-) Clamp Connection
Negative (-) Clamp
Positive (+) Torch
Welding Mask
Wire-brush/Hammer
Welding Current Digital Display
Over-Load Indicator
Power ON Indicator
Welding Current Adjuster
Main Power Lead
Air Cooling Fan

4
UK. Subject to change.
Document Ref: Inverter Welder RH160 53369
Product code: 53369
Copyright: These instructions are the sole property of Rhyas Products and may not be reproduced.
Customer Care Line:- 01568 620062
DECLARATION OF CONFORMITY
The following EU Directives are covered by this declaration:-
Low Voltage Directive: 2006/95/EC
Emc Directive 2004/108/EC Annex II
The following product is covered by this declaration:-
Manufacturers Ref: MMA160 MD branded as RH160 Inverter Welder
The product identified above complies with the requirements of
the stated EU Directives by meeting the following standards:-
EN 55011:2007, EN61000-3-2:2006+A2:2009,
EN 61000-3-3:2008, EN60974-1:2006, EN60974-10:2008
The documentation required to demonstrate the above are available
for inspection.
The CE mark was first applied in 2009.
Signed: A M Riga
Authority: Director
Date: January 2011
Rhyas Products, Unit A Southern Ave, Leominster. HR6 0QF