Ricoh GX4 User manual

1
Network Interface Board GX4
For Machine Code: J012, J013
(Code:J510-17)
INSTALLATION GUIDE
This manual describes how to use the
GX 3000S and GX 3000SF models. (Il-
lustrations are based on the GX
3000SF model.)
Important
❒Be sure to unplug the machine be-
fore installing or removing the net-
work interface board.
❒Do not subject the network inter-
face board to impact or other phys-
ical stress.
1. Ethernet cable connector
ACheck that the power cord of the
machine is not plugged in.
BLift the connector cover.
C Check the network interface board's
orientation, and then install the
network interface board gently.
DClose the connector cover.
AQQ149S
AQQ137S
AQR223S
TosC1_NIB_F-GB_FM_forPaper.book Page 1 Thursday, July 13, 2006 10:20 AM

2
Note
❒Be sure to push the network in-
terface board fully into the ma-
chine.
❒To check whether the network
interface board has been in-
stalled correctly, press the
Menu key and check the menu.
If the network interface board
has been installed correctly,
“Network Settings” appears in
the menu.
❒If the network interface board is
not installed properly, repeat
the entire installation proce-
dure.
❒If you cannot install it properly
even after attempting reinstalla-
tion, contact your sales or serv-
ice representative.
Reference
For details about connecting the
Ethernet cable and specifying
the network settings, see Quick
Installation Guide.
Copyright © 2006
Printed in China
GB GB EN USA J014-8600
TosC1_NIB_F-GB_FM_forPaper.book Page 2 Thursday, July 13, 2006 10:20 AM