Ridetech 11059121 User manual

1812-482-2932
Installation
Instructions
Recommended Tools
Table of contents
Page 2......... Included components and Hardware List
Page 3......... SwayBar Installation
Part # 11059121 - 1958-1964 B-Body Slave Cylinder Bracket Kit
1958-1964 GM B-Body Slave Cylinder Bracket Kit
Installation Instructions
THIS KIT IS DESIGNED TO BE USED WITH THE STREETGRIP SWAYBAR KIT (11059120).

2
www.ridetech.com
Installation
Instructions
Major Components .....In the box
Part # Description QTY
90002532 Slave Bracket 1
Part # Description Usage QTY
99311002 5/16”-18 x 1 1/4” Hex Bolt Bushing Strap to Frame 2
99313003 5/16” SAE Flatwasher Bushing Strap to Frame 2
99312003 5/16”-18 Nylok Nut Bushing Strap to Frame 2
Getting Started.........
THESE INSTRUCTIONS SHOULD BE USED IN CONJUNCTION WITH THE SWAYBAR INSTRUCTIONS.
1. With the swaybar in position, slide the Slave
Cylinder bracket over the end of the swaybar
with the mounting holes to the OUTSIDE of
the car. Position the bracket in the area it will
be mounted.
2. Open up the Poly SwayBar Bushings and
install them over the Delrin Sleeves.
1.
2.

3812-482-2932
Installation
Instructions
SwayBar Installation
3. Install the bushing strap onto the bushing
with the NARROW side to the outside of the
frame. Install a 5/16” flatwasher and 5/16”
nylok on each bolt sticking through the bush-
ing strap and slave cylinder bracket. There
should be 2 bolts sticking through the slave
cylinder bracket and 2 bolts sticking through
both the slave cylinder bracket and bushing
strap. Do NOT Complete tighten the Hard-
ware. It will be left partially loose until the End
Links are installed.
4. Install the End Links. Use Diagram “5”
for proper installation. Tighten the Hex Nut
enough to slightly compress the Bushings.
5. Tighten the Sway Bar Mounting Hardware.
3.
6. Reattached the end of the slave cylinder to the bracket.
4.
SWAYBAR
CONTROL ARM