Ridetech MuscleBar 11289100 User manual

350 S. St. Charles St. Jasper, In. 47546
Ph. 812.482.2932 Fax [phone]
www.ridetech.com
Part # 11289100
65-70 Impala Front MuscleBar
Components:
1 90000104 Sway bar
2 90001100 Bushing and strap kit
2 90000929 12mm end link
2 90001092 Tube of Lithium grease
Hardware Kit: 99010042
2 99122001 12mm x 1.75 Lock nut PosiLink to lower arm
4 99433002 7/16” SAE flat washer PosiLink to lower arm
2 99123001 12mm lock washer PosiLink to sway bar
4 99371004 3/8” x 1 ¼” USS bolt Frame bracket
4 99372002 3/8” USS Nylok nut Frame bracket
8 99373003 3/8” SAE flat washer Frame bracket

11289100 Installation Instructions
*****This sway bar is designed for use with our front StrongArms*****
1. Slide the sway bar though the
same holes in the frame that the
factory bar went through.
2. Install the new polyurethane
bushing over the sway bar.
Lubricate with the Lithium grease
supplied.
3. Slide the frame bracket over the
bushings and clamp the sway bar
up to the frame using a couple “C”
clamps. The sway bar should be
centered in the hole through the
frame.
4. Adjust the frame bracket so that
the corner of the bracket is flush
with the outside of the frame rail.
5. The factory bolt holes will not be
used. Two new holes must be
drilled with a 3/8” bit.
6. Secure the assembly with two
3/8” x 1 ¼” bolts, flat washers and
Nylok nuts.

9. The other end of the PosiLink
will attach to the tab on the
StrongArm using a 12mm flat
washer and locking nut.
10. Check sway bar clearance
through full suspension travel.
11. Congradulations!! Your New
MuscleBar installation is now
complete. If you have any further
questions feel free to contact us at
812-482-2932.
7. Install the lower StrongArms.
8. Screw one end of the PosiLink
into the end of the sway bar. A
12mm lock washer will be used
between the stud and the sway bar.