RIDGID 41636 User manual

2017+ CAN-AM®MAVERICK X3®
DOME LIGHT MOUNT
INSTALLATION INSTRUCTIONS
*THIS MOUNT FITS THE FOLLOWING LIGHTS:
(1) A-Series®
PRODUCT INCLUDES:
(1) Dome Light Mount Bracket #41636
* LIGHTS SOLD SEPARATELY
IMPORTANT
THANK YOU FOR PURCHASING RIGID PRODUCTS FOR YOUR VEHICLE.
Please read through all of these Instructions and tips before proceeding with the installation.
We do our best to provide a simple installation process for all applications however
a professional installation is always recommended.
Always disconnect any power sources connected to your vehicle
before servicing fuses or electrical systems.
STEP 1
Install the A-Series light onto the RIGID dome light bracket using the provided hardware.
STEP 2
Remove the factory rear view mirror bolt and then install the new RIGID bracket. Re-install the factory
bolt and tighten.
See Figures 2, 2.1

STEP 3
Once the mirror bolt is tight, aim light
downward and you are nished with
the installation.
See Figure 3
WARRANTY INFORMATION
For warranty information, visit www.rigidindustries.com/about/warranty
779 N Colorado St, Gilbert, AZ 85233 • 855-760-5337
www.rigidindustries.com
A-Series, RIGID and Rigid Industries are registered and/or common law marks owned by JST Performance, LLC,
a Delaware limited liability company d/b/a Rigid Industries.
11-12459-A
Wiring: Wire your lights according to the instructions included with the light.
Take care to avoid any heat sources and sharp or abrasive surfaces.
Your installation is now complete.
Welcome to the Rigid Nation!
FIGURE 2
FIGURE 2.1
FIGURE 3