RIDGID D Series User manual

2017-2018 FORD®RAPTOR®
FOG MOUNT
INSTALLATION INSTRUCTIONS
*THIS MOUNT FITS THE FOLLOWING LIGHTS:
(6) D-Series®
PRODUCT INCLUDES:
(2) Raptor Fog Mount
* LIGHTS SOLD SEPARATELY
IMPORTANT
THANK YOU FOR PURCHASING RIGID INDUSTRIES’ PRODUCTS FOR YOUR VEHICLE.
Please read through all of these Instructions and tips before proceeding with the installation.
We do our best to provide a simple installation process for all applications however
a professional installation is always recommended.
Always disconnect any power sources connected to your vehicle
before servicing fuses or electrical systems.

FIGURE 1
FIGURE 1.1
FIGURE 2
STEP 1
Remove the 8mm head bolt on the
bumper brace and on the bumper
side, while simply loosening the bolt
on the other end of the brace to allow
it to dangle.
See Figures 1 & 1.1
STEP 2
Install the RIGID fog light bracket as
shown. Using the provided hardware,
install the M6 bolt and washer
through the bumper brace.
See Figure 2
Remove Bolt
Loosen Bolt

FIGURE 3.1
FIGURE 3
STEP 3
Install the provided M6 carriage bolt
and M6 ange head nut as shown.
Do not fully tighten the bolts yet as
further adjustment is required.
See Figures 3 & 3.1
FIGURE 4
STEP 4
Install (6) extended drop mount
brackets as shown, making sure to
pre-install carriage bolts.
See Figure 4

WARRANTY INFORMATION
For warranty information, visit www.rigidindustries.com/about/warranty
779 N Colorado St, Gilbert, AZ 85233 • 855-760-5337
www.rigidindustries.com
D-Series, RIGID and Rigid Industries are registered and/or common law marks owned by JST Performance, LLC,
a Delaware limited liability company d/b/a Rigid Industries.
11-12463-A
Wiring: Wire your lights according to the instructions included with the light.
Take care to avoid any heat sources and sharp or abrasive surfaces.
Your installation is now complete.
Welcome to the Rigid Nation!
FIGURE 5
STEP 5
Once the bracket is on, install the
lights. Adjust the bracket and lights
for proper tment then fully tighten
all bolts.
See Figures 5