RIGIBORE ActiveEdge AE-BPK02 Operating and safety instructions

09-07-2013
1
AE022 - Tool Battery Replacement
The contents of battery replacement kit AE-BPK02 are shown below. Two spare
screws are provided as replacements if required. N.B. Do not mix partially
discharged batteries with new.
Remove the old batteries by undoing the four M4 countersunk socket screws that
secure the battery cover plates to the front of the yoke. Remove the cover plates
and remove the battery packs.
Cover plate
screws (4)
Battery cover
plate (2)
(pressure plate)
'ON' switch

09-07-2013
2
It is essential that replacement batteries are fitted in the orientation shown below
with the written side of the packs facing outward and the battery contacts pointing
downwards into the yoke.
Failure to follow these instructions may cause irreparable damage the Active Edge
control electronics.

09-07-2013
3
Discard the old seals and fit the new ‘O’ rings provided with the AE-BPK02 kit to the
battery cover plates as shown below
'O' Ring Seal
Ensure that the O-ring counterbore on the yoke cap is clean and free from debris.
Carefully replace the battery cover plates taking care to ensure that they are
properly seated into their recesses on the front of the yoke. This action also
compresses the power contacts underneath the battery to ensure a good electrical
connection.
Replace and carefully tighten the four M4 countersunk socket screws provided. Do
not over-tighten.
The tool is now ready for use.
IMPORTANT SA ETY AND PRODUCT IN ORMATION
The battery cover plates must be securely fitted using the socket screws
provided, and in the manner previously described. Any item not securely
attached to the tool prior to use may present an extremely dangerous
flying hazard to persons nearby.
It is essential that the battery cover plates are fitted as described, with all
seals present, clean and undamaged. ailure to follow this procedure may
allow contaminants to enter the yoke, thereby irreparably damaging the
electronic components inside.
The Active Edge yoke is sealed at the time of manufacture and there are no
user-serviceable components inside. Any attempt to gain access to the
yoke will automatically invalidate the product warranty.