RO-T2 RO-T3
T
R-S
F-
R-
Dimensions manually R3
Height [mm]
Height with wooden bench [mm] -
Width [mm]
Width with wooden bench [mm] -
Corpus depth [mm]
Weight
Weight [kg]
Flue pipe connection
R - Ø Flue pipe outlet [mm]
RO - H original angle pipe
connection height [cm]
RO - H with wooden bench [cm] -
RO - T1 original angle pipe
total depth [cm]
RO - T2 original angle pipe
distance to rear wall [cm]
RO - T3 Deapth from rear
wall to middle of flue pipe [cm]
RO - S original angle pipe
side distance [cm]
R - H Rear Connection Height [cm]
R - H with wooden bench [cm] -
R - S Rear Connection Side
Distance [cm]
Fresh air connection
F - Ø Diameter [mm]
F - H Connection Height [cm]
F - H Connection Height with
bench [cm] -
F - S Side Distance [cm]
F - S Side Distance with
bench [cm] -
Note
Please observe the national and European standards as well as
local regulations concerning the installation and operation of
firing installations!
Amount of fuel
Nominal load Part load
Amount of fuel ~ , kg* ~ , kg*
*Practical values may vary depending on fuel quality.
Technical data
Technical data
Heating power range [kW] -
Room heating capacity (depending on
house insulation) [m] -
Fuel consumption [kg/h] up to ,
Electric supply [V]/[Hz] /
Average electrical input [W] ~
Fuse [A] , AT
Efficiency [%] ,
CO2 [%] ,
CO-emission on 13% OO [mg/mN
]
Dust emission [mg/mN
]
Exhaust [g/s] ,
Exhaust temperature [°C] ,
Chimney draft requirement [Pa]
The owner of small firing systems or the person authorised for the
small firing system is to keep the technical documentation and is to
submit it to the authorities or the chimney sweep on request.
Packaging
Your first impression is important to us!
The packaging of your new stove provides excellent protection
against damage. However damage to the stove and accessories
may still occur during transport.
Note
Therefore please check your stove on receipt for damage and
completeness! Report any deficiencies to your dealer immediately!
Pay particular attention during unpacking that the stone panels
remain intact. Scratches to the material can easily occur. Stone
panels are excluded from the warrant.
The packaging of your new stove is environmentally neutral to a
great extent.
Tip
The wood used in the packaging has not been surface treated
and may therefore be burnt in your woodburning stove (not in a
pelletstove!). The cardboard and film (PE) can be depolluted via
the municipal waste collection for recycling.
Electrical connection (RIKATRONIC3)
The stove is supplied with an approx. 2m long connecting cable
with a Euro-plug. This cable is to be connected to a 230Volt/50Hz
socket. The average electrical power consumption is about 4 Watt in
heating operation, and approx. 150 Watt during automatic ignition.
The connection cable must be laid in a way that there is no contact
to any sharp edges or hot surfaces of the stove.
