Rimage Producer III User manual

12000538_C
Producer™ III and IIIN
Align the Printer
This section provides instructions to align the Everest or Prism printer to your autoloader.
Required tools:
#
Torx T25 screwdriver•
5/32” Allen wrench•
Power on the1. autoloader.
Wait for the autoloader to complete initialization.
2.
Tip: The autoloader takes one to two minutes to complete initialization.
Open the
3. front door of the autoloader.
Prepare the unit for alignment.
4.
Manually move thea. lift arm to the top of
the column.
Press one
b. disc into the gripper while
you press the disc release button.
Release the
c. disc release button. The
gripper holds the disc.
Press the
d. printer button. The printer
tray opens.
Open the
5. top access cover.
Tip:
 Look down through the top opening to observe the printer
alignment.
Lift Arm
Disc Release Button
Gripper
Top Access Cover
English

22000538_C
Align the Printer
Align the printer.6.
Slowly move thea. lift arm down until the disc touches the recessed print pad.
If the disc is not centered side to side on the print pad, align the printer side to side.
b.
Loosen the i. side to side screws.
Slide the
ii. printer, not the printer tray, until the disc is centered side to side on the print pad.
Tighten the
iii. side to side screws.
Printer Button
Lift Arm
Holding Pins
Side to Side Alignment
Print Pad
Side to Side Screws
Front to Back Screw
English

3 2000538_C
Producer™ III and IIIN
If the disc is not centered front to back on the print pad, align the c. printer front to back by turning the front to back
alignment screw until the gap between the raised edge of the disc retainer and the disc is correct.
Raise the
7. lift arm out of the way of the printer tray.
Press the
8. printer button. The printer tray closes.
Press the
9. disc release button. The gripper releases the disc.
Tip:
 Place your hand under the disc to catch it.
Close the
10. front door. The autoloader is ready for use.
Everest: 0.063” gap at the front
Disc Retainer Gap
Prism: Disc hangs over the front edge of the print pad by
0.010” – 0.015”
Print Pad Gap
English