Riverside Furniture Somerset Lane 16248 User manual

Be sure to check all packing material carefully for small parts, which may have come loose inside the
carton during shipment. Separate, count and check all parts against the Parts List and Hardware List
above. Failure to use the correct length bolts in the proper locations may result in an unsafe product and
could also cause damage to the parts being assembled.
16248
Pedestal Dining Table - Top
16249
Pedestal Dining Table -
Pedestal Base
Made in Vietnam
Page 1 of 2
AB2 pcs.
Table Leaf
Table Top
2 pcs.
D
JK
1 pc. 1 pc. C1 pc.
Allen Wrench
5mm
2 pcs.
Lower Bridge Panel
(attached)
Upper Bridge Panel
(attached)
1 pc.
H
Pedestal Leg
8 pcs.
Flat Washer
Ø5
16 x 19 x 2mm
16 pcs.
Spring Washer
Ø5
16 x 12 x 3mm
EF
Table Base
G16 pcs.
Ø5 16 -18 x 1-1/2"
Allen Head
Bolt
STEP 1: Place the Table Top (A) upside down on a clean, soft surface such as a blanket or carpet, or its
own packing material. Using the Allen Wrench (H) remove the Bolts and Washers attaching the
Lower Bridge Panels (D) to the bottom side of the Table Top. Lay the Bolts and Washers aside to
reuse.
STEP 2: Attach the Lower Bridge Panels to the top end of the Pedestal Legs (J) using the 1-1/2"
Allen-Head Bolts (E), Spring Washers (G) and Flat Washers (F). Tighten with the Allen Wrench.
Step 1
H
H
F
E
G
Step 2
Riverside
Furniture
Somerset Lane
Dining Room
Assembly Instructions
Components packed in the 16248 Carton (below)
D
D
J
J
8 pcs.
I
Ø5 16 -18 x 2"
Allen Head Bolt
Components and hardware packed in the 16249 Carton (below)

Made in Vietnam
Page 2 of 2
Step 3
H
H
F
I
G
Step 4
TABLE LOCK
Closed position TABLE LOCK
Open position
Step 5
TABLE LOCK
Open position TABLE LOCK
Closed position
Step 6
Riverside
Furniture
Somerset Lane
Dining Room
Assembly Instructions
K
K
16248
Pedestal Dining Table - Top
16249
Pedestal Dining Table -
Pedestal Base
STEP 3: Assemble the Lower Bridge Panel back onto the bottom of
the Table Top using the bolts and washers removed previously.
Tighten Bolts with the Allen Wrench.
STEP 4: Attach the Table Bases (K) to the Pedestal Legs, oriented as
shown, using the 2" Long Allen-Head Bolts (I), Spring Washers
(G) and Flat Washers (F). Tighten with the Allen Wrench.
STEP 5: Using two people, carefully set the assembled, complete
Dining Table upright.
STEP 6: When installing or removing the Leaf, after unlocking the
catches on the underneath side of the Table Top, pull the two
halves of the Table Top apart. Remove or add the leaf, slide the
Table Top back together and re-lock the catches underneath.
Note the orientation of the
Table Base relative to the
Table Top when assembling